CP43维护手册.pdf.pdf - 第91页

6 – 3 V ersion 7.0 Chapter 6 Placing Heads 6.2 How to Remove the Nozzle When removing the nozzle, use nozzle r emoval jig MPJ-1 100. 6.2.1 Removal T o remove the nozzle from the holder , follow the steps below . These st…

100%1 / 167
Chapter 6 Placing Heads
6.1.2 Attachment
(1) After putting the
spring in, put in the
holder.
(2) The correct set position
looking from the front
is such that there is one
nozzle on the left (this
sets the M nozzle).
(3) After inserting the M6
hexagonal nut, spring
washer and flat washer
into the box wrench,
tighten these onto the
assembly.
Fig. 6-2 Holder Attachment
6 – 2
Version 7.0
CP IV-3 Maintenance
6 – 3
Version 7.0
Chapter 6 Placing Heads
6.2 How to Remove the Nozzle
When removing the nozzle, use nozzle removal jig MPJ-1100.
6.2.1 Removal
To remove the nozzle from the holder, follow the steps below.
These steps require the nozzle removal jig MPJ-1100.
(1) Rotate the nozzle by hand to a point where the nozzle catch is
facing the front.
(2) Set the nozzle removal jig, MPJ-1000, on the nozzle stem, as
shown in figure 6-3, and pull toward yourself. This disengages
the nozzle catch, allowing the nozzle to be slid out of the
holder.
Note: One hand should be placed under the nozzle to prevent damage in
case it shoots out.
Fig. 6-3 Nozzle Removal
6.2.2 Attachment
A nozzle is attached simply by inserting the upper step into the
holder and sliding it upward.
CP IV-3 Maintenance
Chapter 6 Placing Heads
6.3 Nozzle Categories
The nozzle sizes listed below must be used with the parts as listed.
S Nozzle ø0.7 1005C/R, 1608 C/R, Super minimold TR
S Nozzle: ø1.0 1608 C/R, 2125 C/R, 3216 C/R
S Nozzle ø1.3 2125 C/R, 33216 C/R, Minimold TR, Tantalum A
M Nozzle ø1.3 2125 C/R, 3216 C/R, Minimold TR, Tantalum A
M Nozzle ø1.8 Tantalum A/B, 3216 C/R, power transistors,
filters, diodes, aluminum electrolytic capacitors
M Nozzle ø2.5 Tantalum B/C/D, power transistors, filters,
aluminum electrolytic capacitors, SOIC 8 ~16,
SSOP 20
L Nozzle ø2.5 SOIC 20, SSOP 24~30, SQFP 48
L Nozzle ø3.7 Tantalum D, SOIC 20~28W, PLCC 18~32,
SSOP 16~30, SQFP 48, SOJ 26
L Nozzle ø5.0 SOIC 20~28W, PLCC 18~32, SSOP 24~30,
SQFP 48, SOJ 26
Note: Nozzle sizes ø7.0 and ø10.0 are only used on the CP-V.
6 – 4
Version 7.0
CP IV-3 Maintenance