雅马哈YSM切刀更换和保养方法..pdf - 第17页
Service Engineer Service Information SI0907002E - 003 = YS machine’s tape cu tter cleaning and lubrication 17 / 63 Step 7 Remov e the six screw s that fasten the feed er bank. Remove the six (6) s crews. (3 each on both …
Service Engineer
Service Information
SI0907002E-003=YS machine’s tape cutter cleaning and lubrication
16/63
Figure 13
Service Engineer
Service Information
SI0907002E-003=YS machine’s tape cutter cleaning and lubrication
17/63
Step 7 Remove the six screws that fasten the feeder bank.
Remove the six (6) screws. (3 each on both sides.)
Note:
The feeder bank fixing screws are tightened to a very high torque. When you loosen the
screws with a wrench, make sure there is nothing that interferes with the handle of the tool in
the work area.
Figure 14
Step 8 Dismount the feeder bank from the machine by two persons.
Carefully lift the feeder bank upwards until the positioning pins on the machine are detached
from the feeder bank.
Caution:
The feeder bank with 60 feeder positions weighs about 30 kg. To ensure safety, be sure to carry the
feeder bank by two persons, NEVER by one person.
Figure 15
Note:
When you dismount and place the feeder bank somewhere temporarily, be careful that the
harnesses do not get caught under the feeder bank.
Service Engineer
Service Information
SI0907002E-003=YS machine’s tape cutter cleaning and lubrication
18/63
Step 9 Disconnect the air hoses used for driving the tape cutter at each quick joint.
Disconnect the air hoses from the bulkhead quick joint at the center of the tape cutter.
Figure 16
Step 10 Remove the tape guide slope Assy. from the machine by removing its three (3) fixing
screws.
Warning:
When the tape guide slope is removed, the cutter blade inside will be exposed. Please be extremely
careful when working on the tape cutter to avoid getting injured.
Figure 17
Bulkhead quick joint
Air hose for driving
the tape cutter
Air hose for driving
the tape cutter
Tape guide slope
Fixing screw