雅马哈YSM切刀更换和保养方法..pdf - 第42页
Service Engineer Service Information SI0907002E - 003 = YS machine’s tape cu tter cleaning and lubrication 42 / 63 3. 5 .2 Tape cutter for the fixed feeder bank with 24 f eeder positions Step 1 Clean th e tape cutter bef…
Service Engineer
Service Information
SI0907002E-003=YS machine’s tape cutter cleaning and lubrication
41/63
When moving the cutter unit to and fro, your finger or hand may get caught in the moving range of the
blade, which will result in serious injury. Please pay close attention when moving the blades.
Service Engineer
Service Information
SI0907002E-003=YS machine’s tape cutter cleaning and lubrication
42/63
3.5.2 Tape cutter for the fixed feeder bank with 24 feeder positions
Step 1 Clean the tape cutter before lubricating it.
Linear guide bearing and the linear guide rail
Although the cleanable areas are limited, remove old grease with a scraper and then clean the
area with cloths.
Cutter blades
Warning:
Be sure to wear cut-resistant leather gloves when cleaning the cutter blade. Otherwise you may get
injured.
Dip a used toothbrush or a brush in isopropyl alcohol and clean the cutter blade. Scrape off
the sticky dirt with a scraper. Then wipe the blade with cloths or cleaning paper soaked with
isopropyl alcohol.
Area around the tape cutter
Remove the dust or fallen objects such as components with a vacuum cleaner.
Step 2 Check the condition of the cutter blades.
Check the cutter blades for chipping, wear and loosening of the fixing screws.
Note:
Should there be any problem, blade replacement is required. If you have a spare blade set,
replace the blades. If not, explain the situation to the customer and be sure to replace the
blades soon.
Step 3 Check the clearance between the cutter blades.
Measure the clearance between the blades of the tape cutter (for the fixed feeder bank with
60/ 24/ 14 feeder positions) to see if it is appropriate. Make a note of the measured result on
the Check sheet.
Tip:
If the blade-to-blade clearances are improper, faulty conditions including premature blade
wear, inability to cut waste tapes, tape jamming or other may result. In this case, check and
adjust the installation condition of the blades. See “SI1109005E = YS machine tape cutter
blade replacement” for the details.
Item
Specified value
Blade-to-blade clearance range
0.02 - 0.03mm
Table 4
[Where to measure]
Measure across the entire blade:
Check that the 0.02mm shim can be
inserted but Not the 0.04mm shim.
Service Engineer
Service Information
SI0907002E-003=YS machine’s tape cutter cleaning and lubrication
43/63
Figure 56