雅马哈YSM切刀更换和保养方法..pdf - 第31页
Service Engineer Service Information SI0907002E - 003 = YS machine’s tape cu tter cleaning and lubrication 31 / 63 Step 4 Disconn ect the air hose from t he feeder bank at the quick joint. Figure 42 Step 5 Remo ve the co…
Service Engineer
Service Information
SI0907002E-003=YS machine’s tape cutter cleaning and lubrication
30/63
2) Unclamp the sATSII by rotating the clamp handle counterclockwise by six (6) turns.
Note:
Do not turn the clamp handle more than the specified number of times. Otherwise the handle
will come off.
Figure 40
3) Attach the sATSII sliding handle to sATSII.
4) Rotate the handle counterclockwise to move the sATSII to its maintenance position.
Figure 41
Rotate the clamp
handle
counterclockwise by
six turns.
Service Engineer
Service Information
SI0907002E-003=YS machine’s tape cutter cleaning and lubrication
31/63
Step 4 Disconnect the air hose from the feeder bank at the quick joint.
Figure 42
Step 5 Remove the cover of the tape cutter driving valve.
Figure 43
Service Engineer
Service Information
SI0907002E-003=YS machine’s tape cutter cleaning and lubrication
32/63
Step 6 Disconnect harnesses from the right and left ends of the feeder bank at each
connector.
Figure 44
Step 7 Remove the feeder floating detection sensor on the feeder bank.
Remove the sensor (Receiver side) together with the bracket.
The sensor harness is attached on the back side of the feeder bank with cable ties. Cut off the
cable ties and free the harness.
Make sure that the harness is NOT secured on the back side of the feeder bank before
removing the feeder bank from the machine.
Figure 45