XP-142E Operator's Guide-TUT-XP142-1.1E.pdf.pdf - 第38页
Chapter 4 Starting Production 4.1 Measurements and Checks Prior to Production 4.2 Starting Production TUT -XP142-1.1E 4-1 XP-142E Operator ’s Guide
Changing the Position of the Back-up Pins
Procedure
1. Lower the panel lifter if it is raised.
2. Adjust the conveyor width to the maximum width.
3. Remove the MFU from the machine.
4. Pull the backup plate sideways slightly, then lift it up to remove
it.
Precautions when mounting/demounting the backup plate:
• Use care to avoid interference between the plate and the sensor. Such
interference could break the sensor.
• Because the procedure is performed from the MFU side, use care to
avoid interference between the camera and nozzles.
5. Detach the back-up pins by loosening their fastening bolt, and
reposition them as necessary.
XP1MC004E
Back-up plate
Panel lifter
Block
(1)
(2)
Chapter 3: Preparing for Production
TUT-XP142-1.1E
3-14 XP-142E Operator’s Guide
Chapter 4
Starting Production
4.1 Measurements and Checks Prior to Production
4.2 Starting Production
TUT-XP142-1.1E
4-1XP-142E Operator’s Guide
Feeder Information
Feeder information is used to verify the part types and slot positions speci-
fied in the recipe, and to check for “parts-out” errors, etc.
Procedure
1. At the [Main] screen, press [Production] then [Feeder Data] to
display the [Feeder Data] screen.
2. Each screen contains boxes, which indicate the statuses of the
feeders in the 20 slots of the MFU. The numbers to the left of
the boxes indicate the slot numbers, and the “O” marks next to
these numbers indicate an error-free status for those feeders
(“X” marks display if “parts-out” errors, etc., occur). “Part data
comment” information displays in the boxes.
4.1 Measurements and Checks Prior to
Production
Chapter 4: Starting Production
TUT-XP142-1.1E
4-2 XP-142E Operator’s Guide