XP-142E Operator's Guide-TUT-XP142-1.1E.pdf.pdf - 第54页
4. Remove the cover on the rear of the machine (side 2), as shown in this diagram. 5. Loosen the ring, remove the filter cover and take out the filter . 6. Clean the filter element with compressed air, or replace the fil…
Point
The vacuum pump is equipped with a dust filter. This filter should be
cleaned/replaced regularly to ensure stable part pick-ups.
Procedure
1. Remove the MFU from the rear of the machine (side 2).
2. Turn the machine power off.
WARNING
Turn off the main circuit breaker before performing
this procedure.
3. Disconnect the air supply, and confirm that the pressure is 0.
XP1MC205E
0
7.5 Cleaning the Vacuum Pump Filter
(Every Week)
Chapter 7: Maintenance
TUT-XP142-1.0E
7-6 XP-142E Operator’s Guide
4. Remove the cover on the rear of the machine (side 2), as shown in this
diagram.
5. Loosen the ring, remove the filter cover and take out the filter.
6. Clean the filter element with compressed air, or replace the filter element.
Filter Cover
O-ring
O-ring
F
ilter element
XP1MC208E
Ring
Filter cover
Ring
Loosen
XP1MC207E
Cover
XP1MC206E
Chapter 7: Maintenance
TUT-XP142-1.0E
7-7XP-142E Operator’s Guide
Point
If oil or dust accumulate on the strobe light half mirror or prism surface,
problems such as light intensity and image distortion will cause vision
processing errors.
Procedure
WARNING
Turn off the main circuit breaker before performing
this procedure.
CAUTION
Do not press hard when cleaning the thin strobe light
half mirror because it breaks easily.
Clean the strobe light half mirror and prism surface with a lens cloth, or
commercially available glass cleaner, etc.
XP1MC209E
Strobe light half mirror
Prism surface
7.6 Cleaning the Strobe Light Half
Mirror and Prism Surface
(Every Week)
Chapter 7: Maintenance
TUT-XP142-1.0E
7-8 XP-142E Operator’s Guide