XP-142E Operator's Guide-TUT-XP142-1.1E.pdf.pdf - 第59页
It is possible to set the sequence from which production is to start. Procedure 1. At the [Automatic] screen, select [Start number]. 2. Use the numeric keypad to input the number of the sequence from which production is …
Chapter 8
Production Support Functions
8.1 Setting the Production Start Sequence
8.2 Loading a New Panel
8.3 Unloading Panels
8.4 Panel Lifter Up/Down
8.5 Pass Mode Operation
TUT-XP142-1.1E
8-1XP-142E Operator’s Guide
It is possible to set the sequence from which production is to start.
Procedure
1. At the [Automatic] screen, select [Start number].
2. Use the numeric keypad to input the number of the sequence
from which production is to start, then press [CR].
3. Press the START button.
Note: If fiducial mark acquisition has not been completed for the panel on the
main conveyor, production will start from the specified sequence but
after the fiducial marks are read.
A new panel can be loaded onto the main conveyor by means of a command
operation.
Procedure
1. At the [Main] screen, press [Manual Operation] then [Conveyor
Operation].
2. Find [Other], then press [Load New Panel].
8.2 Loading a New Panel
8.1 Setting the Production Start Sequence
Chapter 8: Production Support Functions
TUT-XP142-1.1E
8-2 XP-142E Operator’s Guide
All panels remaining in the main conveyor can be unloaded.
Procedure
1.
At the [Main] screen, press [Manual Operation] then [Conveyor
Operation].
2. Find [Other], then press [Unload Panel].
The panel can be clamped or unclamped by raising or lowering the main
lifter.
Procedure
1. At the [Main] screen, press [Manual Operation] then [Conveyor
Operation].
2. Find [Main Station], then press one of the following: [MAIN
LIFTER UP] or [MAIN LIFTER DOWN].
8.4 Panel Lifter Up/Down
8.3 Unloading Panels
Chapter 8: Production Support Functions
TUT-XP142-1.1E
8-3XP-142E Operator’s Guide