00191657-0102_UM_Luftkissentransportsystem_DE EN.pdf - 第65页

Air cushion t ransporting system for SIPLACE Operating Instructions 10/99 edition 5.2 Preparing the load t o be transported 23 : The ce nter of gr avity s hould be as ce ntral as poss ible betwe en the m odule s. : Make …

Operating Instructions Air cushion transporting system for SIPLACE

5.2 Preparing the load to be transported 10/99 edition

: The sheets can also be butted together, if necessary.

: Cover rough floors, cable ducts, etc, with 1 mm thick sheets.

: The joints must be clean before the adhesive tape is attached.

: Check for potential obstacles such as narrow or low doors, door sills, etc.

If the air cushions can be pushed under the load to be transported: 5

Transport height = Height of load to be transported + inflated height 5

If the load to be transported has to be placed on the air cushions: 5

Transport height = Height of load to be transported + inflated height + height of air cushion

module 5

WARNING RISK OF CRUSHING 5

: If the floor is not horizontal, secure the load well to prevent it slipping off.

5.2 Preparing the load to be transported

Fig. 5.2 - 1 Distribution of the air cushions about the load’s center of gravity

: To ensure that the load is stable, arrange four (or at least three) air cushion modules as far

apart as possible beneath the load to be transported.

Center of gravity of load

Air cushion transporting system for SIPLACE Operating Instructions

10/99 edition 5.2 Preparing the load to be transported

: The center of gravity should be as central as possible between the modules.

: Make sure that the air cushions are not tilted.

Warning:

All loose or moving parts on the load to be transported must be secured to prevent people being

injured by parts that fall off or swing out. Sharp or pointed edges and parts must be made safe.

WARNING RISK OF INJURY

Everything on the load to be transported that could represent a hazard if damaged (e.g. glass,

leakage of gas or liquid) must be firmly secured. Any containers filled with liquid must be sealed.5

Fig. 5.2 - 2 Possible arrangements / positions

: The contact surface must not be too narrow, otherwise the air cushion could tip over.

: The contact surface of the load to be transported should ideally cover 2/3 of the air cushion

supporting plate.

RightWrong

Operating Instructions Air cushion transporting system for SIPLACE

5.3 Structure of the transport system 10/99 edition

5.3 Structure of the transport system