Micron Technical Reference V9 Volume 4.pdf - 第243页
TRANSPORTATION - MAJOR RELOCATION MACHINE ASSEMBLY Chapter Issue 2, Jul 16 Technical Reference Manual 43.103 10. Fit the combined cap and 4mm tubing to the solvent container . 1 1. Connect the cable from the external sol…
TRANSPORTATION - MAJOR RELOCATION
MACHINE ASSEMBLY
43.102 Technical Reference Manual Chapter Issue 2, Jul 16
2. Move the angle brackets away from the support plate.
3. Remove the rear cover of the machine (front cover on style 4 machines).
4. Place the external solvent tank on the floor beneath its intended location.
5. Supporting its weight, lift the external solvent tank and locate the support
plate on the machine base frame, as shown in the graphic below:
6. Place a full solvent container into the external solvent tank.
7. Remove the cap from the solvent container.
8. Locate the combined solvent container cap and 4mm tubing, inside the
machine.
9. Pass the cap through the hole in the external solvent tank base plate, from
underneath.
Support Plate
Angle Brackets
Support Plate Machine Base Frame (Cross Section)
NOTE
Baffles removed for clarity
TRANSPORTATION - MAJOR RELOCATION
MACHINE ASSEMBLY
Chapter Issue 2, Jul 16 Technical Reference Manual 43.103
10. Fit the combined cap and 4mm tubing to the solvent container.
11. Connect the cable from the external solvent tank to 9SK69 on the external
services panel.
12. Fit the rear cover (front cover on style 4 machines).
Solvent Container Cap
Base Plate
View on Rear of Machine
POWER ON
PART No. 160740
M/C AVAILABLE
BOARD AVAILABLE
BOARD PASS
D
O
W
N
L
IN
E
BOARD AVAILABLE
BOARD PASS
M/C AVAILABLE
U
P
L
IN
E
FMI POD
Solvent Fluid
Connector
Solvent Sensor
9SK69
TRANSPORTATION - MAJOR RELOCATION
MACHINE ASSEMBLY
43.104 Technical Reference Manual Chapter Issue 2, Jul 16
13. Slide the angle brackets towards the machine cover, ensuring that either the
vertical or sloping side as appropriate, abuts the machine cover.
14. Tighten the two M5 cap head securing screws.
Tooling and Print
Medium
Applicators
Any material applicator or tooling removed from the machine prior to it’s move
should be refitted. Refer to the individual item chapter or the tutorial set supplied
with the machine.
Power Up On completion of relocation, carry out the procedure in the Transportation -
Power Up chapter.
Machine Cover
Securing Screws
Angle Brackets