00196062-03_SM_LDU-X_EN.pdf - 第58页
4 Service Work 4.2 Replacing Spare Parts 58 Service Manual SIPLACE LDU-X Linear Dipping Unit 11/2017 4.2.29.2 Dismantling the Refill Unit NOTICE To temporarily remove the refill unit from the LDU-X frame, proceed as foll…
4 Service Work
4.2 Replacing Spare Parts
Service Manual SIPLACE LDU-X Linear Dipping Unit 11/2017 57
View from the left side, after opening the
side cover panel.
► Unplug the connector from the display
board connection(2).
► Unplug the connector(3) from the
connection for the LDU-X control
board.
Installation
Installation is performed by following the above instructions in the reverse order.
Both connectors have the same PIN arrangement which is why they both fit wither in the connec-
tion for the LDU-X control board or that for the display board.
► Plug one of the cable connectors into the connection marked on the display board.
► Plug the other cable connector into the connection marked on the LDU-X control board.
► Replace the two cable ties which you removed earlier on.
► Fit the left side cover into place (see section 4.2.29.10 "Fitting the Side Covers" [}65]).
4.2.29 Frequent Service Tasks
The steps described in this chapter are partial steps needed for service work. The service work to
be performed is indicated in these partial steps.
4.2.29.1 Removing the Side Covers
► Loosen the 6 screws (1) fastening the
left side cover(2) and then remove
the cover.
► Do the same for the right side cover.
4 Service Work
4.2 Replacing Spare Parts
58 Service Manual SIPLACE LDU-X Linear Dipping Unit 11/2017
4.2.29.2 Dismantling the Refill Unit
NOTICE
To temporarily remove the refill unit from the LDU-X frame, proceed as follows:
The flat ribbon cable remains connected to the LDU-X.
For details of how to perform complete removal of the refill unit, refer to section .
► Loosen the 2 marked screws.
► Carefully pull the refill unit in the direc-
tion of the arrow and out of the LDU-X
frame.
4.2.29.3 Removing and Dismantling the LDU Basis
► Loosen the two screws(2) fastening
the LDU base unit(1).
The upper section of the LDU base unit is
connected to the lower section of the LDU
base unit with 3 screws.
► Loosen the first screw(1) fastening
the upper section of the LDU base
unit.
CAUTION!
Cup springs
Take care not to lose the cup
springs(2) (29x time, in pairs).
.
4 Service Work
4.2 Replacing Spare Parts
Service Manual SIPLACE LDU-X Linear Dipping Unit 11/2017 59
► Loosen the two adjustment screws at
(1) and(2) for the upper section of the
base unit (see next diagram).
CAUTION!
Make sure that you do not lose the
supports.
.
Adjustment screw
1. Allen screw M4
2. Spring washers (4 x)
3. Adjustment screw with fine thread
4. Base plate of application unit
5. Threaded hole of clamping screw
6. Contact surface
7. Adapter base plate
► Take the upper section of the base
unit(2) off the lower section of the
base unit(1).