COU2000 PRO计数器英文说明书 Operaton Manual-en(1).pdf - 第13页

VERSION: .1.01 E 13 / 52 time, m ultiply the "DA T A" count value by 4 to obtain the m aterial spacing. For example, i f the cou nt value of two adjacent materia ls is 3, then the material spacing i s: 3 * 4 mm…

VERSION: .1.01 E

12 / 52

2mm；4mm；8mm；12mm；16mm；20mm；24mm；28mm；32mm；36mm；40mm；44mm；

48mm；52mm；56mm；

Press the PITCH key continuously to set the correct pitch value

When long pressing PITCH, the pitch will flash, and you can quickly modify the pitch value

as shown in the following figure

The value of pitch is equal to P, which is the distance between adjacent components on the

carrier tape, and the value of P. (EIA-481 has standardized that the P0 of all material strips is

4mm)

When the pitch value is greater than 4mm and it is inconvenient to confirm, counting gear

can be used to assist in confirming the material spacing: adjust the pitch value to 4mm, let

the arrow on the guide pulley randomly point to the center point of a material, press the

"reset" button, and then manually pull to the center point of an adjacent material. At this

S2 DATA PITCH PRESET

000000 **mm

VERSION: .1.01 E

13 / 52

time, multiply the "DATA" count value by 4 to obtain the material spacing. For example, if

the count value of two adjacent materials is 3, then the material spacing is: 3 * 4mm=12mm.

PRESET：When it is expected to count a certain number of parts, we use the preset function

After pressing the PRESET key and entering the value, the machine will stop at the

corresponding position, and only minor adjustments are needed to obtain the required

quantity; Press the PRESET key again to clear the set value, and the pre stop function will be

disabled.

Note:

1. Due to the limitation of the counting range, preset values above 999999 are invalid;

2. Negative numbers can be preset.When setting a negatiive value, press "0" first, then press

other numbers。

CLEAR：When starting counting, be sure to reset it to zero first, otherwise the counting will

be inaccurate。

START ：Press START key,the right motor starts to rotate clockwise, the left motor is driven,

and the count value increases. The reel strip gradually rolls into the temporary reel from the

original reel of the parts

STOP：Press STOP key to stop the motor rotation。

REWIND：The left motor starts to rotate counterclockwise, the right motor is driven, and the

count value decreases. The material strip is gradually rolled back to the original part reel

from the temporary reel. Note that when the count value decreases to zero, the machine

will automatically stop. At this time, the material strip should return to the starting point,

and the accuracy of the count can be confirmed again. Press the REWIND key again, and the

material strip will continue to rewind until it completely returns from the temporary reel to

the original part reel

4.1.4 Adjust the arm for reel in different size

Rotate the locking knob counterclockwise to adjust the arm: When using a 7-inch/180cm

DATA PITCH PRESET

000000 4mm ******

VERSION: .1.01 E

14 / 52

reel, place the arm at a 45 degree angle to the chassis; When using a 13 inch/330 cm or

larger reel, please place the arm at a 90 degree angle to the chassis, rotate the locking knob

clockwise, and lock the arm to the fixed bracket. We recommend fixing the arm angle at 45

degrees, which is compatible with both large and small material trays

7-inch/180cm reel --45°

13inch/330cm or larger --90°