COU2000 PRO计数器英文说明书 Operaton Manual-en(1).pdf - 第32页

VERSION: .1.01 E 32 / 52 (as above), and then roll th e gear fo r a full ci rcle 5.1.4.5 Restor e factor y setting 5.1.4.5.1 Pow er on and wait f or mo re than 5 seconds 5.1.4.5.2 Press and hold th e " FEED" bu…

100%1 / 52
VERSION: .1.01 E
31 / 52
5.1.4.4 Ribbon installation
5.1.4.4.1 Open the upper cover of printer and keep it in open position。
5.1.4.4.2 Release the print head lock column and open the print head module to a vertical
position.。
5.1.4.4.3 Open the ribbon and insert the ribbon supply end into the ribbon supply end slot
(first insert the left end of the ribbon)
Insert the paper tube into the left slot, apply slight force to the left, and insert the paper
tube at the right end of the carbon ribbon into the right slot
5.1.4.4.4 Insert the carbon ribbon recycling paper tube into the carbon ribbon recycling slot
VERSION: .1.01 E
32 / 52
(as above), and then roll the gear for a full circle
5.1.4.5 Restore factory setting
5.1.4.5.1 Power on and wait for more than 5 seconds
5.1.4.5.2 Press and hold the "FEED" button for about 10 seconds, and the "READY" and
power indicator lights will turn off in sequence。
5.1.4.5.3 Release the "FEED" button when the two indicator lights light up in sequence。
5.1.4.5.4 At this point, the printer will send out a 12 inch long blank label and restore the
factory settings。
The above are solutions for situations where the printer may be damaged or set incorrectly.
All settings will be stored in the printer and will not be lost when the power is turned off。
5.1.4.6 Printer panel operation guide
VERSION: .1.01 E
33 / 52
Power Switch
Control power connection or disconnection status
Note: when connecting communication lines or power cords, be sure that the switch is on
the OFF location.
FEED Key
Feed paper to the next location
Press slightly once—Feed paper to the next location
In the continuous print status, slightly press the FEED key—Enter the pause
status
Slight press the FEED key in the pause status—Enter the normal print status
Ready Indicator
Display the power and error statuses OFF—The printer is off
Green—The printer is started
Flash—There is an error, and check against the following table:
The POWER and READY indicators flash
contemporaneity
The POWER and READY indicators flash
alternately
Possible problem
Solution
Possible problem
Solution
Label spacing
cannot be found
Check the label path
Check the label detector
The carbon ribbon is
used up
Reinstall carbon
ribbon
Paper is used up
Reload paper roll
The carbon ribbon is
blocked
Clean up the carbon
ribbon
The paper roll is
not loaded
Load the paper roll
The carbon ribbon
Detector goes wrong
Replace the carbon
Ribbon detector