DEK INFINITY USER MANUAL.pdf.pdf - 第127页
INFINITY 6(735()(5( 1&(6 ,1752'8& 7,21 Soft ware Ver sion 7 User Manual 2.1 CHAP TER 2 SET PREFERENCES INTRODUCTION The Set Preferences function allows for the setting of preferr ed machine control options.…
INFINITY
0$&+,1(352*5$00,1*
67$7863$*(
1.124 User Manual Software Version 7
INFINITY
6(735()(5(1&(6
,1752'8&7,21
Software Version 7 User Manual 2.1
CHAPTER 2 SET PREFERENCES
INTRODUCTION The Set Preferences function allows for the setting of preferred machine control
options.
To access the set preferences window proceed as follows:
1. Select Maint. (F8).
2. Select Set Prefs (F5).
The set preferences window is displayed:
The menu bar changes to give the following options:
Next and Previous move the highlight between the various parameters.
Incr. and Decr. alter the value of the highlighted parameter.
Run Head
Paste
Load
Clean
Screen
Adjust Setup Monitor Maint.
Calibrat
Pressure
Calibrat
Offset
Calibrat
Vision
House
Keeping
Set
Prefs
Diagnost
Tes t
Cycles
Exit
Set Preferences
secs
..more
TRANSPORT MODE
MACHINE UNITS
UPLINE PROTOCOL
DOWNLINE PROTOCOL
TRANSFER PERIOD
SELECTIVE PRINT/PASS
PASTE DISPENSE POS.
COMMS PROTOCOL
EVENT RECORDING
TOOLING HARDWARE
FIDUCIAL REFERENCE
PRODUCT BARCODE H/W
SCREEN BARCODE H/W
REMOTE BARCODE H/W
LEFT TO LEFT
Metric
NO FMI
NO FMI
20
ENABLED
FRONT
NO COMMS
GROUP 3
MAGNETIC
LEFT
NOT FITTED
NOT FITTED
NOT FITTED
Next Previous Incr. Decr. Exit
INFINITY
6(735()(5(1&(6
35()(5(1&(6
2.2 User Manual Software Version 7
PREFERENCES
Transport Mode Sets the input and output side of the printer, options are:
Machine Units Sets the unit of measurement, options are:
Upline Protocol Sets the protocol for transferring boards from adjacent machines, options are:
Downline Protocol Sets the protocol for transferring boards to adjacent machines, options are:
Transfer Period Sets a programmable time period used by certain transfer protocols, options are:
Period of Transfer Time - This is the period of time which the machine allows
for a transfer of a board before displaying a ‘Board Transfer Error’ for upline
or downline.
Period of Waiting Time - This is the period of time which the machine allows
when waiting for the upline or downline machine to request a board for transfer
before displaying a message of ‘Waiting for Upline/Downline’.
Options Default
Left to Right Left to Right
Right to Left
Right to Right
Left to Left
No Transfer
Options Default
Metric Metric
Imperial
Options Default
No FMI Specified by Customer
Requirements
MIU
Manual
Options Default
No FMI Specified by Customer
Requirements
MIU
Manual
Minimum Maximum Increment Default
0 Seconds 999 Seconds 1 Second 20 seconds