2OM-1751-003w_G5S.pdf - 第288页

2OM-1751 6-16 4.2.1 Stocker Area Edit Procedure Note This section is described based on the front reference and PCB ow direction from left to right. Procedure (1) Press [Sprt-Pins] button in the "Setup" main m…

2OM-1751

6-15

[7] [Undo] Button

When pressed, the parameters are returned to the original ones before the

change is applied.

[8] [Apply] Button

When pressed, the changed arrangement parameters in the stock area are

applied.

[9] [Cancel] Button

When pressed, the editing operation is ended.

Any arrangement parameter that has not been applied is cancelled.

1303-001

4.2 "Stkr.Area Edit" Window

2OM-1751

6-16

4.2.1 Stocker Area Edit Procedure

Note

This section is described based on the front reference and PCB ow direction

from left to right.

Procedure

(1) Press [Sprt-Pins] button in the "Setup" main menu bar to display the

following window.

F2F16

(2) Press the [PCB Support Pins Exchange Pos. Movement] button and within

10 seconds, press the [START] button on the operation panel.

(The head will retract and the conveyor width becomes the maximum one.)

(3) Press the cover lock switch and turn off the light on the switch.

(The transparent covers are unlocked).

(4) Open the transparent covers.

CAUTION

The load power to the motors, etc., is turned OFF

but the setup operation must be performed carefully

when you put your hand inside the machine. Avoid

hand and nger injuries.

(5) Insert the PCB support pins directly into each hole in the stock area on the

backup table.

Notice

In the case that any operation is to be performed on the backup

table, when any strong pressure is applied to the backup table such

as touching the backup table with your hand to support your body

or putting an object on the backup table, it might be deformed. Take

the greatest care.

1303-001

4.2 "Stkr.Area Edit" Window

2OM-1751

6-171303-001

(6) Make sure that no PCB support pins are left on the backup table.

(Make sure that no components or debris drop into any of the backup table

holes).

(7) Close the transparent covers.

(8) Press the cover lock switch to turn ON the light on the switch.

(The transparent covers are locked).

(9) Using the PCB locating section selection button, select the stock area for

which the parameters are edited.

Side L Side R

Stkr.Area

F2F17

(10) Press the [Stkr Area Edit] button to display the following window.

F2F18

4.2 "Stkr.Area Edit" Window