CP45FVNEO Maintenance Reference (Eng, Ver3).pdf - 第100页

Samsung Component Placer CP45NEO Series Maintenance Guide  Questioning dialog box appears. Click the yes (Y) button.  Using the teaching box, move the X-axis to the adequate position for grease injection on the lead sc…

100%1 / 139
Lubricant Method
4-11
Caution
The designated grease must be applied using the
designated lubricator in the designated manner. Other
lubricating methods are unacceptable.
4.2.3. Conveyor
4.2.3.1. Lead Screw and LM Guide for Adjusting Conveyor Width
Inspection
Look for components, dust or discoloration of the lead screw.
Insufficient lubricant on the lead screw can cause difficulty in adjusting the width of
the conveyor. Check the lubricant condition.
Figure 4-4. Lead Screw for Adjusting Conveyor Width
Solution
Click the ‘PCB Edit’ on the menu tool-bar of the main menu on the MMI, click
‘Board’ on the menu tool-bar of the auxiliary menu, enter the maximum size of
400mm in the Y direction of the conveyor in the ‘Y Edit Box’ of ‘7. Board Size’ area,
and click ‘Conv. Width button’. [Large PCB Type maximum size (460mm)]
Samsung Component Placer CP45NEO Series Maintenance Guide
Questioning dialog box appears. Click the yes (Y) button.
Using the teaching box, move the X-axis to the adequate position for grease injection
on the lead screw of the conveyor and the LM guide.
Warning
After clicking the “Motor Free” button on the teaching box,
click the “Stop” button on the front operation panel.
Conduct inspection while the motor power supply is turned
off.
Remove dust and foreign matter from the LM guide rail and LM screw using the
clean cloth in the clean kit supplied by us.
Apply grease thinly on the lead screws of the entry and exit using a paint brush.
4-12
Lubricant Method
4-13
Inject adequate volume of grease through LM guide grease nipples (A) and (B) at the
entry and exit of the conveyor using the grease injection device provided by us.
Upon completion of injection, reciprocate from the minimum width (30mm) to the
maximum width (400mm) of the conveyor 3 to 4 times in order to uniformly spread
the grease on the lead screw and LM guide rail. [Minimum width (90mm) to
maximum width (460mm) of large PCB type]