CP45FVNEO Maintenance Reference (Eng, Ver3).pdf - 第112页
Samsung Component Placer CP45NEO Series Maintenance Guide Change to the main menu by pressing <Esc> key , and then enter into the 'IDE HDD auto detection'. Select the 'LBA' from the list. …
Inspection of the Controller
7-3
LED lit green: The monitor is operating in normal.
LED is blinking
The monitor is in power saving mode.
Check to see if the monitor cable is connected properly.
Check to see if the Video card is installed properly.
LED is off
Check to see if the power switch of the monitor is on.
Check to see if the power supply cable is connected properly.
Check to see if the power is being supplied.
Check to see if the CP2 is cut off and the power is not supplied, if so turn the
power off and unplug the power cable, and then re-supply the power by using
the CP1.
Check to see if the Video card is installed properly.
7.2.2.2.2. Hard Disk Drive (HDD)
Inspection for the power supply
Check to see if the PC Power module connector is connected properly.
Check to see if the HDD cable is connected properly.
In case of the PC cannot detect the HDD
Check to see if the HDD is set as 'MASTER'.
JP4 □ □
JP3 □ □
JP2 □ □
JP1 □━□
Figure 7-3. HDD Jumper Setting
HDD detection
First turn the power on, and then change to CMOS Setup mode by pressing
the <F2> or <Delete> key.
Select the Standard CMOS Setup Menu from the main menu, and then
change the HDD type to 'AUTO' by using <>, <>, <>, <> keys at
the Primary Master.
Samsung Component Placer CP45NEO Series Maintenance Guide
Change to the main menu by pressing <Esc> key, and then enter into the
'IDE HDD auto detection'.
Select the 'LBA' from the list.
Change to the main menu by pressing <Esc> key, and then select the 'SAVE
& EXIT Setup' to store current setting.
The PC may detect the HDD after automatic re-booting.
Booting using the FDD
Follow the below procedures in case of the 'IDE HDD auto detection' is not
available.
Select the 'BIOS Features Setup' from the CMOS Setup main menu, and then
7-4
Inspection of the Controller
7-5
set the boot sequence as 'Boot Sequence: A, C' by using the <Pg Up>, <Pg
Dn> keys.
Change to the main menu by pressing <Esc> key, and then select the 'SAVE
& EXIT Setup' to store current setting.
Insert the Windows 98 startup disk into the FDD and then reboot.
Check the HDD status by using ' SCANDISK C:' command at the DOS
command line.
If the HDD has been damaged, contact to service center.
7.2.2.2.3. Floppy Disk Drive (FDD)
Inspection for the power supply
Check the power supply referring to the below diagram.
Figure 7-4. Inspection for the power supply of FDD
Check to see if the FDD cable is connected properly.