CP45FVNEO Maintenance Reference (Eng, Ver3).pdf - 第54页

Samsung Component Placer CP45NEO Series Maintenance Refer ence 3.1.2. V acuum Filter Inspection Problem to the vacuum can occur when the v acuum filter has been contaminated by dust in the air or due to solder p aste. Ch…

Weekly Inspection

3-3

 Lower the spindle to the position where a spanner can enter into the spindle hole (A)

and hexagonal part (B) of the nozzle holder.

Nozzle Holder

 Hold the head spindle groove(A) with the 7mm spanner and the hexagonal area(B) of

the nozzle holder with the 8mm spanner and remove the nozzle holder by applying

force on the 7mm spanner counterclockwise while applying the same force on the

8mm spanner clockwise.

 Assembling is done in the reverse order.

Caution

In case the nozzle holder is removed or assembled with the

spindle by applying too excessive force, the spindle may be

bent or excessive force may be imposed on the spindle

threads. Remove or assemble the nozzle holder applying

appropriate force

Samsung Component Placer CP45NEO Series Maintenance Reference

3.1.2. Vacuum Filter

Inspection

Problem to the vacuum can occur when the vacuum filter has been contaminated by dust

in the air or due to solder paste. Check the vacuum filter regularly to make sure the filter

element is free from contamination.

Figure 3-2. Vacuum Filter Inspection

Solution

Vacuum Filter

 Move the nozzles installed on the spindle of the head assembly to ANC using the

“Put All Nozzle” command.

3-4

Weekly Inspection

3-5

 Operate the teaching box to move the Head Assembly to the front side as far as

possible so that front and rear head assemblies do not interfere with each other.

Warning

After clicking the “Motor Free” button on the teaching box,

click the “Stop” and “Reset” buttons on the front operation

panel. Conduct inspection while the motor power supply is

turned off.

 If the working space is insufficient, move the head assembly manually to the front

side

 After terminating the MMI and computer, Turn off the main switch on the front

side of the machine.