CP45FVNEO Maintenance Reference (Eng, Ver3).pdf - 第91页

Lubricant Method 4-3  Reference How to use a grease gun Grease Gun Set : Grease gun-1(ea), Grease nipple-2(ea), Nipple tip-2(ea) Using a grease gun for the conveyo r and LSO unit, Use the long type nipple tip Using a gr…

Samsung Component Placer CP45NEO Series Maintenance Guide

 Check the grease injection status while operating the machine slowly by using the

Teaching Box.

 For even application of grease, warm up the machine for 1 minute before application.

How to apply grease

First, remove any dust or contaminant with antidust cloth, and apply the grease thinly on

the surface of the rail and screw groove with a brush. Then slowly move the axis twice or

three times to remove any excessive grease on the rail and both ends of the screw.

If there is a lot of dust in the environment, it is best to remove chips or dust on the rail

thoroughly and apply grease often even before the regular grease lubrication period.

 Recommended brush Type : The brush for paint coating (hog or horse hair brush)

 Recommended grease application amount: 1cc/application for one block

Pyoundo Paint Brush Paint Brush For Painting

Grease storage method

 A grease container must be opened in a clean environment devoid of dust.

 Wipe the utensil to take out the grease thoroughly and use. Do not use a wooden

spatula. If chips of wood get mixed up in the grease, severe problems could occur

 The oil separation phenomenon could occur in the grease left unused for a long time.

If this happens, mix it well before using it.

 If grease is taken out from the center of the container and the scooped up spot is left

untouched, the oil separation phenomenon gets aggravated as the gravity is

concentrated in the scooped up area. Raise the center area slightly and store.

 If the lid of the grease container gets damaged, moisture could penetrate or grease

could be oxidized due to contact with air. Take precautions.

4-2

Lubricant Method

4-3

 Reference

How to use a grease gun

Grease Gun Set : Grease gun-1(ea),

Grease nipple-2(ea), Nipple tip-2(ea)

Using a grease gun for the conveyo

and LSO unit, Use the long type nipple

tip

Using a grease gun for the x-axis an

y-axis, Use the short type nipple tip.

1. Pull the cylinder lever back and fill

with grease.



3. Push the cylinder lever slightly and

remove the air in it using the handle.

2. Join the grease nipple and the body.

For the conveyor, LSO: long type nipple tip For the X-axis,Y-axis: short type nipple tip

Samsung Component Placer CP45NEO Series Maintenance Guide

4.2. Lubrication and Grease Application

Caution

It may shorten the average life span of a machine if grease

not specified by our company is applied on the machine.

Use the grease specified by our company.

4.2.1. Head

Inspection

 Check the Ball Spline or the rail for discoloration or dust.

 Noise may be generated if the lubricant has become too dry. Therefore, check the

state of lubrication.

Figure 4-1. Head Assembly Application

Solution

LM Guide Rail

 Operate the teaching box to move the head assembly to the front side as far as

possible.

4-4