CP45FVNEO Maintenance Reference (Eng, Ver3).pdf - 第101页

Lubricant Method 4-13  Inject adequate volume of grease through LM guide grease nipples (A) and (B) at the entry and exit of the conveyor using th e grease injection device provided by us.  Upon completion of injection…

Samsung Component Placer CP45NEO Series Maintenance Guide

 Questioning dialog box appears. Click the yes (Y) button.

 Using the teaching box, move the X-axis to the adequate position for grease injection

on the lead screw of the conveyor and the LM guide.

Warning

After clicking the “Motor Free” button on the teaching box,

click the “Stop” button on the front operation panel.

Conduct inspection while the motor power supply is turned

off.

 Remove dust and foreign matter from the LM guide rail and LM screw using the

clean cloth in the clean kit supplied by us.

 Apply grease thinly on the lead screws of the entry and exit using a paint brush.

4-12

Lubricant Method

4-13

 Inject adequate volume of grease through LM guide grease nipples (A) and (B) at the

entry and exit of the conveyor using the grease injection device provided by us.

 Upon completion of injection, reciprocate from the minimum width (30mm) to the

maximum width (400mm) of the conveyor 3 to 4 times in order to uniformly spread

the grease on the lead screw and LM guide rail. [Minimum width (90mm) to

maximum width (460mm) of large PCB type]

Samsung Component Placer CP45NEO Series Maintenance Guide

4.2.3.2. Chain for Adjusting Conveyor Width On Manual Operation

Inspection

 Check for contamination on the chain.

 Insufficient lubricant on the chain could cause difficulties in adjusting the conveyor

width. Check the condition of the lubrication.

Figure 4-5. Chain for Adjusting Conveyor Width On Manual Operation

Solution

Repeat 2 to 3

times.

Chain

Belt

 Using the teaching box, move the X-axis to the adequate position for grease injection

on the chain for manual width adjustment.

4-14