YRM20_Mainte_E.pdf - 第88页
2. Monthly maintenance items 3-21 Chapter 3 Periodic maintenance items 2.5 The feeder exchange carriage and clamp unit on machine side 2.5.1 The feeder exchange carriage and positioning unit on machine side Basically , t…
2. Monthly maintenance items
3-20
Chapter 3 Periodic maintenance items
4
Set new filter into hole of filter insertion
tool.
1. Insert needle pierce into hole of filter.
2. Insert filter deeply into hole of tool. At this
time, be careful not to deform the filter, and
also to align the hole number with the
number of shaft which filter is to be
replaced.
c
CAUTION
Make sure to set the filter facing up the hole side.
5
Insert tool into shafts.
1. Align the tool hole number with the number
of shaft which filter is to be replaced.
2. Push up the tool completely to arrows'
direction as shown on the right.
c
CAUTION
Make sure to push up the tool completely. If pushing up
the tool incompletely or insertion position is deviated,
filters get deformed.
6
Check that filters are surely inserted
into shafts after detaching the tool.
7
Attach the acrylic board removed in
Step 2 to its original position.
8
Return nozzles to original positions if
nozzles are detached manually.
1. Return nozzles to original positions.
2. Retrieve the square cloth.
n
NOTE
Make sure to return the nozzle to the head from which the
nozzle is detached.
c
CAUTION
Make sure to return all nozzle shafts to the original
position after lowered nozzle shafts manually.
►
Replacing filter without filter insertion tool
Insert filters into shaft using a tweezers,
and push them to the end of shaft with tips
of tweezers.
c
CAUTION
Make sure not to deform filter or damage to shaft.
Setting filters
Step 4
Filter
Needle pierce
Example: Replacing filters for all heads
Filter insertion tool
Filters-are-set status
533F7-KMX-00
Inserting tool
Step 5
Push up tool aligning numbers
Check that shaft tip and
tool hole are aligned
533F8-KMX-00
Checking filter insertion condition
Step 6
Check that filters are
surely inserted
533F9-KMX-00
Inserting filters
Nozzle shaft
Check the filter direction
Tweezers
Hole side must face up
53339-KMX-00
2. Monthly maintenance items
3-21
Chapter 3 Periodic maintenance items
2.5
The feeder exchange carriage and clamp unit on machine side
2.5.1
The feeder exchange carriage and positioning unit on machine side
Basically, the cleaning and lubrication for the 2 positioning pins of feeder exchange carriage and the 2
positioning holes on machine are required once a month. Clean and lubricate the 4 positions illustrated below.
1
Wipe away adhered grease using a lint-free cloth.
2
Apply reasonable amount of prescribed grease (NSL) using a cotton swab.
Positioning unit
Cleaning and lubrication points
2 positioning pins
2 positioning holes
Feeder exchange carriage side
Machine side
533H5-KMX-00
2. Monthly maintenance items
3-22
Chapter 3 Periodic maintenance items
2.5.2 Cam follower of feeder exchange carriage
Basically, cleaning and lubrication of the cam follower of feeder exchange carriage are required once a month.
1
e
Detach feeder exchange carriage while pressing the emergency stop button.
2
Clean up 7 cam followers of feeder exchange carriage by wiping away adhered
grease and dirt using a lint-free cloth.
3
Apply prescribed grease (NSL) thinly coated the cam followers using fingers, and
wipe away the excessive grease..
Cam follwer
Cleaning and lubrication points
4 cam followers
3 cam followers
533H6-KMX-00