LA 404-2 Pattern Controller Manual.pdf - 第33页
LA 404-2 Pattern Control System 27 P/N 7 1 1 9995A 2006 Nordson Corporation LA 4 04- 2 Is sued 12/06 Administrator M ode T o access Admin istrator mode , press the buttons , and one of t he SETUP -buttons for 2 seconds w…
LA 404-2 Pattern Control System
26
P/N 7119995A
2006 Nordson Corporation
LA 404-2
Issued 12/06
Operator mode
Operator mode is always active after switching the unit on. After exiting
from Setup mode, Operator mode is automatically activated.
The following menus are available in Operator mode:
Production Data refer to Page 28
Pressure 1 Settings refer to Page 32
Pressure 2 Settings refer to Page 32
Normal Beads refer to Page 37
Program (1-100) refer to Page 48
Warnings refer to Page 49
V3.26
Initializing
Operator
O662
Setup Mode
To access Setup mode, press the buttons and for 2 seconds when in
Operator mode. Exit from the mode by pressing the buttons and again
for 2 seconds and Operator mode is reactivated.
The following menus are available in Setup mode:
Production Data refer to Page 28
Trigger Assignment refer to Page 29
Trigger (1-4) Settings refer to Page 31
Pressure 1 Settings refer to Page 32
Pressure 2 Settings refer to Page 32
Purge Pressure refer to Page 34
Bead Type (Channel 1-4) refer to Page 37
Program (1-100) refer to Page 48
Warnings refer to Page 49
V3.26
Initializing
Setup
O663
LA 404-2 Pattern Control System
27
P/N 7119995A
2006 Nordson Corporation
LA 404-2
Issued 12/06
Administrator Mode
To access Administrator mode, press the buttons , and one of the
SETUP-buttons for 2 seconds when in Setup or Operator mode. Press the
, buttons and one of the SETUP-buttons for 2 seconds again to exit the
mode.
All the menus are available in Administrator mode:
Production Data refer to Page 28
Trigger Assignment refer to Page 29
Trigger (1-4) Configuration refer to Page 30
Trigger (1-4) Settings refer to Page 31
Pressure 1 Settings refer to Page 32
Pressure 2 Settings refer to Page 32
Purge Pressure refer to Page 34
Channel 1-4 Driver Setup refer to Page 35
Channel 1-4 Compensation refer to Page 36
Bead Type (Channel 1-4) refer to Page 37
Program (1-100) refer to Page 48
Warnings refer to Page 49
Encoder Scaling refer to Page 50
Low Speed Setting refer to Page 51
System Settings 1 refer to Page 52
System Settings 2 refer to Page 54
Tip Sealer Settings refer to Page 55
V3.26
Initializing
Administrator
O664
LA 404-2 Pattern Control System
28
P/N 7119995A
2006 Nordson Corporation
LA 404-2
Issued 12/06
Production Data
This menu offers the following parameters:
The program number is displayed. The program number is changed
after loading a different program.
Speed indicates the line speed measured by the encoder in meters
per minute. The speed is purely an indicator and cannot be altered.
Work rate is the production rate determined by Trigger 1.
Total is the number of products currently counted by Trigger 1.
Products below the low speed of the production line are not counted.
To reset Total, press the button on the front panel of the pattern
controller.
Program 1..100
Speed 60 m/min
Work rate 0/hr
Total 0
O665