00194655-01.pdf - 第55页
Service Manual: Replacement of ball screw for SIPLACE MTC2 lifting axis 05/2005 Edition 55 : Remove the two sets crews for setting the belt tension for the motor support s on both sides of the MTC2. 2 2 : Loosen 4 clampi…
Service Manual: Replacement of ball screw for SIPLACE MTC2 lifting axis
05/2005 Edition
54
: Remove the sensor mounts (2 screws).
2
2
: Dismantle the synchronizing disk / thrust sleeve from the spindle.
2
2
2
Sensors
Sensor
mounts
Spindle synchro-
nizing disk
Service Manual: Replacement of ball screw for SIPLACE MTC2 lifting axis
05/2005 Edition
55
: Remove the two setscrews for setting the belt tension for the motor supports on both sides of
the MTC2.
2
2
: Loosen 4 clamping screws on each side.
2
2
2
Remove the
setscrews
4 clamping screws
Service Manual: Replacement of ball screw for SIPLACE MTC2 lifting axis
05/2005 Edition
56
: Push the motor inwards on both sides in order to slacken the belts.
: Remove the toothed belts on both sides.
: Remove the motor.
: Loosen the screws on the cover of the feed axis and remove the cover.
2
: Raise the tray supply manually and place a suitable lifting device (such as the wooden block
in the photograph) beneath it so it cannot slip down.
2
2
2
2
2
2
2
2
2
2
Lifting device