00194655-01.pdf - 第64页
Service Manual: Replacement of ball screw for SIPLACE MTC2 lifting axis 05/2005 Edition 64 : Lift up the tr ay supply and insert the device needed to hold the tray supply up. : Loosely tighten the scr ews of the spindle …
Service Manual: Replacement of ball screw for SIPLACE MTC2 lifting axis
05/2005 Edition
63
: Insert the preassembled spindle from above and allow the tray supply to descend slowly at the
same time.
2
Insert the spindle so that enough space remains for the spindle nut block. 2
Check that the contact surface between the nut block and the support bracket is clean (e.g. lost
components). 2
2
: Fit the bottom locating bearing without tightening the screws.
: Move the spindle nut block to the same height as the service cover.
: Press the spindle forward (towards the feed axis).
2
Spindle nut block
Preassembled spindle
Push the spindle
forward
Service Manual: Replacement of ball screw for SIPLACE MTC2 lifting axis
05/2005 Edition
64
: Lift up the tray supply and insert the device needed to hold the tray supply up.
: Loosely tighten the screws of the spindle nut block.
: Move the spindle nut to a height that allows the middle pin to be fitted.
: Insert the pin. The pin has phase at the back and thread at the front.
Turn the spindle so that the pin slips in. The clearance is 0.2 mm.
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
Service Manual: Replacement of ball screw for SIPLACE MTC2 lifting axis
05/2005 Edition
65
: Insert the top locating bearing so that the spindle (after being inserted) does not have too much
clearance.
2
2
Insert the locating bearing
Polished side down
Unpolished side up