00194655-01.pdf - 第68页
Service Manual: Replacement of ball screw for SIPLACE MTC2 lifting axis 05/2005 Edition 68 : Firmly tighten the screws of the top spindle nut b lock. 2 2 : Screw down the tray su pply using the cordless screwdriver . : L…
Service Manual: Replacement of ball screw for SIPLACE MTC2 lifting axis
05/2005 Edition
67
: Loosely tighten the four screws on the spindle nut block using a diagonal sequence.
2
2
: Attached the angled plate and loosely tighten the four screws.
2
2
Tighten 4 screws
using diagonal
sequence
Service Manual: Replacement of ball screw for SIPLACE MTC2 lifting axis
05/2005 Edition
68
: Firmly tighten the screws of the top spindle nut block.
2
2
: Screw down the tray supply using the cordless screwdriver.
: Loosen the four screws on the spindle nut block and then tighten them again in a diagonal se-
quence to eliminate any twisting.
: Tighten the bottom four screws on the thrust bearing.
2
2
2
4 screws
Service Manual: Replacement of ball screw for SIPLACE MTC2 lifting axis
05/2005 Edition
69
: Remove the old version of the thrust sleeve if it is fitted:
2
: In this case, place the new sleeve on the spindle.
: Tighten the screws evenly using a diagonal sequence to avoid stresses.
2
: Remove the motor support from the motors (4 screws) and screw on the new one (see photo-
graph).
: Replace the belt tension adjusting screws with longer ones.
2
Thrust sleeve, old version (DSK 15.28) Thrust sleeve, new version DSL 15.28
Motor support
Motor
Adjusting screws
Motor pinion