00195988-02_IM_SWS-Software-2.1_DE_EN.pdf - 第90页

Installation Manual SIPLACE SWS Software 2.1 Edition 05/2014 90  Open the terminal with CTRL + AL T + X. 2 Fig. 2 Opened terminal  Enter the following at the te rminal: Launch  Enter your p assword. 2 Fig. 3 Entry of …

100%1 / 164
Installation Manual SIPLACE SWS Software 2.1
Edition 05/2014
89
2 Installing the Operating System
2
2.1 Creating a Backup of the Installed SWS Software
2
Proceed as follows:
Connect a USB stick to the port provided on your computer.
2
Fig. 1 USB port on SWS monitor
2
2
PLEASE NOTE
Backup of installed SWS software version
If you replace the computer, first perform a backup of the operating system and the SWS
control (see “Backup des Betriebssystems und der SWS-Software” auf Seite 66). This
backup can then be used to install the operating system (see Installing the Operating
Systemon page 93) and the control software.
If you need to perform a backup of the operating system at the customer site, you will first
need to back up the installed SWS software.
PLEASE NOTE
To achieve the required effect, confirm each entry with Enter.
Installation Manual SIPLACE SWS Software 2.1
Edition 05/2014
90
Open the terminal with CTRL + ALT + X.
2
Fig. 2 Opened terminal
Enter the following at the terminal: Launch
Enter your password.
2
Fig. 3 Entry of launch and password
2
To change the test USB disk folder, enter the following: cd /asm
Enter the following: ls /media/usbdisk0
2
Fig. 4 Entry of cd/ asm and ls /media/usbdisk0
– The USB stick contents will be shown.
Installation Manual SIPLACE SWS Software 2.1
Edition 05/2014
91
To store the wafer feeder SW packages on the USB stick, enter the following:
tar -cvzf /media/usbdisk0/wfBackup.tgz ./wf 2
2
Fig. 5 Entry of tar -cvzf /media/usbdisk0/wfBackup.tgz ./wf
– After the process has been executed, the following will appear on your screen:
2
Fig. 6 Screen after process execution