00195655-04_SM_X-Series_FSE_en.pdf - 第112页

Item no.: 00195655-04 ASM Assembly Systems GmbH & Co. KG Rupert-Mayer-Strasse 44 81379 München Germany www.siplace.com

100%1 / 112
Service Work
Cutter 3.9.1 Replacing the Cutter Blades [03009259-xx]
110 Service Manual (internal version) SIPLACE HF and X Series
► Reinsert the tape deflector unit (3) and screw in the 4 hexagon socket-head screws (4) by hand.
► Push the spacers (with inserted shim) as far as possible in the direction of the moveable blade. The
maximum permissible gap is 1.0 mm.
► In this position, tighten the 4 screws (4) on the tape deflector holder crosswise (tightening torque).
► Remove the two feeler gauges.
► Insert the new stationary blade (5) in the correct position and screw tight.
Final work
If the gap is correct:
► Replace the protective plate, baffle plate and cover plate. Make sure that the edges are parallel.
► Remove the clamps form the cutter/ remove the cutter from the assembly plate.
► Fit the cutter.
► Lubricate the contact/slide surfaces for the moveable
blade, as described in the section "Preparation".
CAUTION!
Do not lubricate the blades themselves.
► Place a feeler gauge (0.5 - 1.0 mm thickness) on the
left and right, between the spacer and the front of the
moveable blade (1).
► Place the previously removed holding-down device
(2) onto the new spacers.
⇨ The holding-down devices with function status 03
are designed for use with cutters of function status
-04 (= with tape deflector).
1
2
4
1
5
4
3
2
► Use a feeler gauge to check the gap between the
tape deflector (1) and the moveable blade (2), along
the entire length and width of the blade.
⇨ The 0.05 mm feeler gauge should fit through the
gap.
⇨ The 0.25 mm feeler gauge should not fit through
the gap.
If the gap is not correct, check:
▪ Whether the wrong holding-down device has been in
-
stalled (with function status < 03)
▪ The holding-down devices are those designed for
cutters with function status -04 (= with tape deflector)!
▪ Whether the blades, tape deflector etc. were cleaned
before installation
CAUTION
Make sure that the cables and hoses are not trapped or subjected to excess strain.
acpage
Item no.: 00195655-04 ASM Assembly Systems GmbH & Co. KG
Rupert-Mayer-Strasse 44
81379 München
Germany
www.siplace.com