00192324-0302_MM_MTC1-MTC2_EN.pdf - 第40页
Maintenance Preventive Maintenance MTC 2 2 MTC 2 10/2010 US Edition 40 2 – Pull the piston as far as possible (end s top) out of the filling tube. 2 – Open one end of the cartridge, by pulling on the plastic ring to remo…
Preventive Maintenance MTC 2 Maintenance
10/2010 US Edition 2 MTC 2
39
Procedure 2
2
– Screw the rubber tank hose provided onto the threaded connector at the head of the grease
gun.
– Tighten the nut on the rubber tank hose with a 17 mm open-ended wrench.
2
– Turn the filling tube anticlockwise to unscrew it from the gun head.
2
2
2
2
2
2
2
Maintenance Preventive Maintenance MTC 2
2 MTC 2 10/2010 US Edition
40
2
– Pull the piston as far as possible (end stop) out of the filling tube.
2
– Open one end of the cartridge, by pulling on the plastic ring to remove the base.
– Open the other end of the cartridge, by pulling off the lid.
2
– Push the open cartridge (open at both ends) as far as possible into the filling tube.
NOTE: The cartridge will only fit into the filling tube if you insert the end with NO rim. This cartridge
rim must be aligned with the edge of the filling tube (see arrow on the diagram above). 2
Preventive Maintenance MTC 2 Maintenance
10/2010 US Edition 2 MTC 2
41
2
– Press the filling tube against the head of the grease gun.
– Turn the filling tube clockwise to screw it into the gun head, as far as the end stop.
2
– Press the locking lever to release the piston.
The piston will be automatically pressed against the grease by the spring in the filling tube.
2
– Press your finger against the ball valve, to vent the grease gun.