00192324-0302_MM_MTC1-MTC2_EN.pdf - 第41页
Preventive Maintenance MTC 2 Maintenance 10/2010 US Edition 2 MTC 2 41 2 – Press the filling tube against the head of the grease gun. – T urn the filling tube clockwise to sc rew it into the gun h ead, as far as the end …
Maintenance Preventive Maintenance MTC 2
2 MTC 2 10/2010 US Edition
40
2
– Pull the piston as far as possible (end stop) out of the filling tube.
2
– Open one end of the cartridge, by pulling on the plastic ring to remove the base.
– Open the other end of the cartridge, by pulling off the lid.
2
– Push the open cartridge (open at both ends) as far as possible into the filling tube.
NOTE: The cartridge will only fit into the filling tube if you insert the end with NO rim. This cartridge
rim must be aligned with the edge of the filling tube (see arrow on the diagram above). 2
Preventive Maintenance MTC 2 Maintenance
10/2010 US Edition 2 MTC 2
41
2
– Press the filling tube against the head of the grease gun.
– Turn the filling tube clockwise to screw it into the gun head, as far as the end stop.
2
– Press the locking lever to release the piston.
The piston will be automatically pressed against the grease by the spring in the filling tube.
2
– Press your finger against the ball valve, to vent the grease gun.
Maintenance Preventive Maintenance MTC 2
2 MTC 2 10/2010 US Edition
42
2
– To fill the rubber tank hose with grease, pump the lever until grease appears at the end of the
rubber tank hose.
The grease gun is now ready for use.
2
2
2
2
2
2
2
2