00192324-0302_MM_MTC1-MTC2_EN.pdf - 第45页
Preventive Maintenance MTC 2 Maintenance 10/2010 US Edition 2 MTC 2 45 The towers are each guided with fo ur linear guides, two in the upper area an d two in the lower area of the tower carrier. Each upper linear guides …
Maintenance Preventive Maintenance MTC 2
2 MTC 2 10/2010 US Edition
44
Note:
In case of older MTCs the lubrication nipples of the linear guides points to the inner side, therefore
it is not possible to fit the grease gun. Using a wrench SW 8 you can turn the lubrication nipples
to the outer side and then fit the grease gun. 1
1
1. Lubrication nipple for the greasing of the spindle nut.
1
– Fit the universal grease gun mouthpiece onto the lubrication nipple of the spindle nut.
– Pump the grease gun twice.
– Remove the grease gun.
– Use a dry cloth to remove any residual grease from on and around the lubrication nipple.
1
The greasing of the spindle nuts must be performed on both towers. 1
1
1
1
1
1
1
1
1
Preventive Maintenance MTC 2 Maintenance
10/2010 US Edition 2 MTC 2
45
The towers are each guided with four linear guides, two in the upper area and two in the lower
area of the tower carrier.Each upper linear guides is equipped with one lubrication nipple at the
top. Each lower linear guides are equipped with one lubrication nipple at the bottom. Thus there
are 8 lubrication nipples. 1
1
1. Upper lubrication nipples at the linear guides for tower 1 (left image)
and for tower 2 (right image)
1
1. Lower lubrication nipples at the linear guides on tower 1 and 2.
1
– Fit the universal grease gun mouthpiece onto the lubrication nipple of the spindle nut.
– Pump the grease gun twice.
– Use a dry cloth to remove any residual grease from on and around the lubrication nipples.
– Screw the covers and side plates on the MTC again.
– Dock on the MTC to the placement machine and start the operation of the MTC again.
1
1
1
Maintenance Preventive Maintenance MTC 2
2 MTC 2 10/2010 US Edition
46
1.9 Bi-Annual Maintenance Work
1
The bi-annual maintenance work is to be performed by instructed service stuff. 1
1
1
: Change the battery of the controller boards
1
1