00193922-01.pdf - 第208页
4 Setting up and commissioning User Manual SIPLACE HF Series 4.6 Adapting the com ponent trolley to the PCB transport height Software Version S R.505.xx 05/2004 US Edition 208
User Manual SIPLACE HF Series 4 Setting up and commissioning
Software Version SR.505.xx 05/2004 US Edition 4.6 Adapting the component trolley to the PCB transport height
207
4.6.3.2 Reducing the component trolley height
For this task you will need two other people to press in the height marking pins to allow the top
part to be lowered.
WARNING
Do not use your fingers to press the marking pin back into the openings. Use a flat object, such
as a screwdriver blade or a ruler, otherwise you may hurt your fingertips.
Æ Lower the top part to the required height.
Æ Check that the top part is lying on the marking pins.
Æ Tighten the four flange bolts.
Æ Unscrew the eye-bolt from the component trolley bed.
4 Setting up and commissioning User Manual SIPLACE HF Series
4.6 Adapting the component trolley to the PCB transport height Software Version SR.505.xx 05/2004 US Edition
208
User Manual SIPLACE HF Series 5 Tasks on the machine
Software Version SR.505.xx 05/2004 US Edition 5.1 Personnel profile
209
5 Tasks on the machine
This chapter contains a number of subjects that are intended to help you during your daily work
on a SIPLACE line.
For example, you are provided with preventative measures that you can take to minimize the down
time on the machine to obtain the highest possible level of efficiency for the SIPLACE line during
production.
In addition, the tasks of the operator and of the line engineer are described in an operator and line
engineer profile, respectively, in this chapter.
5.1 Personnel profile
5.1.1 Operator
5.1.1.1 Tasks of the operator
The operators should generally have attended the SIPLACE Operation-Training course or have
been familiarized by trained personnel.
The operating personnel are to be assigned the following tasks:
– Checking the assignment of components to the feeders
→ In addition, a set-up check is to be carried out several times a day, preferably at the start of
a shift, to make sure that the correct components are set up.
– Supplying the feeder with sufficient components
– Promptly refilling the components and splicing the tapes
– Checking to make sure that the components are in their correct pick-up positions (see Fig. 5.7
- 2)
– Checking the flow of material to the PCBs on the input and output conveyor
– Checking the set-up quality
– Random sampling of the PCBs before they enter the soldering furnace.
– Observing the ESD regulations
– Preventing errors (see Section 5.7
, page 222)
– Observing the fault displays and messages at the station and passing the information on to the
line engineer if necessary
– Carrying out the preventive maintenance work specified in the Preventive Maintenance Man-
ual