KE2040Instruction Manual Ver2.01,REV04.2003.6.25.pdf - 第837页
12 − 18 ③ I nfor mation of Coplanarit y − No output − O nly error electr ode infor mation − All elect rode inf ormat ion Check the cor responding r adio button t o output t he desired inf ormation. W hen you validate the…
12 − 17
12.4.6 Setting the Production (Check) option
When you select the [Options] command on the menu bar, then [Option Setting]
command on the Options menu, the Operation option setting dialog box appears on
the screen.
When you select the <Production (Check)> tag, the Production (Check) option setting
screen appears as shown in Figure 12.4.6.
(You can select this tag only when using a KE-2020/2040.)
Figure 12.4.6 Production (Check) option setting screen
(Display example: KE-2020 screen)
(1) How to set the item
① Properties checked
− Only Colinearity checked
− Colinearity and Coplanarity checked
Check the corresponding radio button to perform the desired check.
② When Copla check fails
− Pause: the system pauses.
− Place without checking: the system places a component on a board
without checking it.
− Put into trash box: the system discards a component into a trash box.
Check the corresponding radio button to select the operation to be
performed when the system cannot perform the selected check.
Only when you check the radio button “Pause”, it allows you to set
the menu item “Information of Coplanarity”.
12 − 18
③ Information of Coplanarity
− No output
− Only error electrode information
− All electrode information
Check the corresponding radio button to output the desired information.
When you validate the selected item(S), click the <OK> button. If you do not want to
set any option, click the <CANCEL> button.
☞
12 − 19
12.4.7 Setting the Use Unit option
When you select the [Options] command on the menu bar, then [Option Setting]
command, the Operation option setting dialog box appears on the screen.
When you select the <Use Unit> tag, the Use Unit option setting screen appears as
shown in Figure 12.4.7.
Figure 12.4.7 Use Unit option setting screen
(Display example: KE-2020 screen)
(1) How to set the item
① Tombstone detection
− Using the check box, set whether to detect a tombstone error.
− When you check the check box of this option, the "Tombstone det." setting
of Component data becomes effective.
② Component different check
− Using the check box, set whether to check a component whose size is
different from the regular ones.
− When you check the check box of this option, the "Acceptable width
(length, and height)" setting of Component data becomes effective.
③ Component orientation check
− Using this check box, set whether to check a component posture.
− When you check this check box, the system compares the ratio of the
shorter side to the longer side specified in Component data and the ratio
measured. If the difference between the ratio in Component data and the
measured ratio is not within a certain range, it is regarded as a component
posture error.