00197975-06_UM_TX-Serie_EN.pdf - 第206页

4 Setting up and commissioning Us er manual SIPLACE TX-Series 4.5 Setting up the placement mac hine From software version 713.0 Edition 01/2020 206 4.5.5.2 Fork-lif t attachment point s on the placement machine A pallet …

User manual SIPLACE TX-Series 4 Setting up and commissioning

From software version 713.0 Edition 01/2020 4.5 Setting up the placement machine

205

4.5.5.1 Safety instructions

 During transportation, also observe the safety instructions in section 4.1, page 175 and in

section 4.3.1

, page 185.

DANGER

Risk of placement machine tilting due to eccentric center of gravity!

There is a risk of tilting if the required specifications for the fork-lift and the attachment

points on the placement machine are not observed!

 The placement machine may only be lifted at the locations using the specified pallet

truck. The pallet truck must compensate the eccentric center of placement machine

gravity. Observe the specifications of the pallet truck (see section 4.5.5.3

, page 207).

WARNING

Risk of damage due to one-sided loading!

One-sided loading of the machine feet e.g. from tilting the machine, can lead to deforma-

tion of the machine feet.

 Make sure that the forks are evenly loaded when you lift the placement machine.

 Use a firm support layer between the forks and the placement machine.

 Enlist the help of a second person to watch while you lift the placement machine and

make sure that the placement machine does not tip over to one side.

WARNING

Take care of the supply channel!

Lifting the SIPLACE TX over a supply channel which is run under the placement machine

is not permitted. There is a risk that the SIPLACE TX could fall off the pallet truck.

 If a supply channel has been run under the placement machine position, before the

SIPLACE TX is positioned in the placement line, then this supply channel must be

removed again.

4 Setting up and commissioning User manual SIPLACE TX-Series

4.5 Setting up the placement machine From software version 713.0 Edition 01/2020

206

4.5.5.2 Fork-lift attachment points on the placement machine

A pallet truck may be used to lift the placement machine at the locations, to place it in the line or

lift it out of the line.

Fig. 4.5 - 4 Placing the machine into a line or lifting it out of a line

(T) Direction of travel for PCB conveyor

(1) Pallet truck forks

(2) Risk of tilting due to eccentric center of gravity.

 Position the forks of the pallet truck in the location area. The steel spacers (item 2 in fig. 4.5

- 3, page 204) limit the fork position so that the center of placement machine gravity is com-

pensated.

 Open the forks until the forks are up against the metal sheets for limiting the fork positions

and the contact surfaces of the placement machine can lie evenly on the forks.

 Push the forks into the location area, so that the placement machine can lie safely along the

whole length of the forks.

 Positioning the placement machine in the line.

(2)

(1)

User manual SIPLACE TX-Series 4 Setting up and commissioning

From software version 713.0 Edition 01/2020 4.5 Setting up the placement machine

207

4.5.5.3 Pallet truck specification for lifting at the locations

The pallet truck must compensate the uneven weighting on its forks and guarantee a horizontal

position when loaded.

If you lift the placement machine at the locations, you will need to use a pallet truck with the fol-

lowing specifications:

Fork length Min. 1800 mm

Lifting power Min. 3000 kg