00197975-06_UM_TX-Serie_EN.pdf - 第254页

5 Tasks at the placement machi ne User manual SIPLACE TX-Series 5.9 Carrying out a sight check Fro m software versio n 713.0 Edition 01/2020 254 5  Check the multicolor sta tu s display (item 3 in fig. 5.9 - 1 , page 25…

User manual SIPLACE TX-Series 5 Tasks at the placement machine

From software version 713.0 Edition 01/2020 5.9 Carrying out a sight check

253

5.9 Carrying out a sight check

5.9.1 Checking the X feeder modules

Fig. 5.9 - 1 Checking the X feeder modules

(1) Flap

(2) Blade

(3) Status display

(4) LED display

 Check to see whether the tape foil removal container for the X tape feeder module is full.

 Open the flap (item 1). Pull out the cover foil and cut it off with the blade (item 2).

(1)

(2)

(3)

(4)

5 Tasks at the placement machine User manual SIPLACE TX-Series

5.9 Carrying out a sight check From software version 713.0 Edition 01/2020

254

 Check the multicolor status display (item 3 in fig. 5.9 - 1, page 253).

– If it lights up green, the feeder module is on standby.

– If it lights up orange, it is signaling a warning. The LEDs will shine accordingly.

– If the status display lights up red, a malfunction has occurred. The LEDs will shine ac-

cordingly.

A list of the LED and status displays on the SmartFeeder operator panel is given in sec-

tion 5.11

, page 267. 5

If the status display is off, the cause may be as follows: 5

– The feeder module is not in the current setup.

– The feeder module is defective.

– The feeder module has been disabled (due to a drop in pressure, for example)

5.9.2 Splicing the tapes in good time

CAUTION

Problems with cover foil withdrawal!

If the cover foil tears, this could lead to problems with the cover foil withdrawal.

PLEASE NOTE

Late splicing of tapes

Late splicing of tapes can lead to prolonged down times.

 Splice the tapes early enough so that the feeder modules do not run out of compo-

nents.

PLEASE NOTE

Early splicing of tapes

Early splicing of tapes can have the following consequence: when the old tape is rolled

up onto the new reel, the new reel could become too full and the tape will slide off it and

get caught up. This will again result in pick-up errors and prolonged down times.

User manual SIPLACE TX-Series 5 Tasks at the placement machine

From software version 713.0 Edition 01/2020 5.9 Carrying out a sight check

255

5.9.3 Checking the PCB supports

 Check the position of the magnetic PCB supports on the lifting table:

– Make sure that the PCB supports do not collide with components on the underside of the

PCBs.

– In addition, make sure that the PCB supports do not collide with the PCB conveyor pan-

els.

– Only use PCB supports as described in section 6.9

, page 313.