00197975-06_UM_TX-Serie_EN.pdf - 第232页
5 Tasks at the placement machi ne User manual SIPLACE TX-Series 5.3 Switching on the SIPLACE line From software version 713.0 Edi tion 01/2020 232 5 Fig. 5.3 - 2 Flow chart - switching o n the "SIPLACE line" St…
User manual SIPLACE TX-Series 5 Tasks at the placement machine
From software version 713.0 Edition 01/2020 5.3 Switching on the SIPLACE line
231
5.3.4 start button action
The action performed by the start button can be set.
Open the "Check sensors and functions" view (see section 5.5.3, page 236).
The following settings are possible:
Start production automatically 5
Standard setting.
Pressing the start button automatically begins the production process.
Do not change production status 5
This is used, for example, to calibrate and test the placement machine
Pressing the start button simply closes the control circuit; production is not started immediately.
5
5.3.5 "Switching on the SIPLACE line" flow chart
The following flow diagram shows the actions performed after the SIPLACE line has been
switched on.
CAUTION
Placement machine functions can be directly started via the GUI, irrespective of the start
button setting. Once the control system has been switched on, you no longer need to
press the start button on the placement machine.
5 Tasks at the placement machine User manual SIPLACE TX-Series
5.3 Switching on the SIPLACE line From software version 713.0 Edition 01/2020
232
5
Fig. 5.3 - 2 Flow chart - switching on the "SIPLACE line"
Station computer
Switch on
Check setup
(configure feeder modules
Teach fiducials
Load board data
Press start button
Wait for reference run
Move board in
Wait for PCB
Check setup
(if table marked red
If required: change nozzle configuration
Nozzle check
Fiducials
OK?
Track error
Placement
Check setup
Fill up tracks
Placement
PCB in output conveyor
Italics: Performed or reported by the station
Yes
Yes
No
No
Presettings on the
placement ma-
chine
Download assistant
Programming system
Tasks
Confirm conversion in download
assistant
Bold lettering: job to be performed by op-
erator
User manual SIPLACE TX-Series 5 Tasks at the placement machine
From software version 713.0 Edition 01/2020 5.4 Switching off the SIPLACE line
233
5.4 Switching off the SIPLACE line
5
5.4.1 Switching off the stations
To switch off the stations, proceed as follows:
End all placement procedures, so that there are no more boards in the placement machine.
Check whether the Z axes of all placement heads are in their uppermost end positions.
Check whether there are still components on the placement heads and remove these.
Close the station computer software in the view
Settings --> Machine settings --> Shut down the placement machine...
Once the computer has been shut down, wait for the relevant message on the monitor at lo-
cation 2 and then switch off the station at the main switch.
5.4.2 Exiting SIPLACE Pro (Windows)
In the SIPLACE Pro menu, select Object --> Close.
Close all other programs on the computer.
Select Shut down from the Windows Start menu.
CAUTION
Before you switch off the line, observe the following procedures.