00197182-04_AI_Prepare_Kit_SX12_de_en.pdf - 第67页

Assembly Instructions / Montageanleitung SIPLACE SX1/SX2 Prepare Kit 04/2017 3 Fitting the Prepare Kit 3.5 Fitting the Trailing Cable 67 ► Connect the flat ribbon cable to the trailing cable interface and the hotlink ada…

3 Fitting the Prepare Kit

3.5 Fitting the Trailing Cable

Assembly Instructions / Montageanleitung SIPLACE SX1/SX2

Prepare Kit 04/2017

Fig.20: Pneumatic hoses

Connection for compressed air line in the machine

► Fix the two spacer bolts M4x10 to the trailing cable cover with the trailing cable and then

secure them with Loctite 241.

Fig.21: Fixture for trailing cable

Fig.22: Running the trailing cable

► Run the flat ribbon cables around the trailing cable cover and thread them through to the trail-

ing cable interface.

► Fit the trailing cable cover to the machine base.

Fig.23: Fixing the protective tape onto the trailing cable

► Fix the protective tape onto the trailing cable with

a cable tie.

Assembly Instructions / Montageanleitung SIPLACE SX1/SX2

Prepare Kit 04/2017

3 Fitting the Prepare Kit

3.5 Fitting the Trailing Cable

► Connect the flat ribbon cable to the trailing cable interface and the hotlink adapter.

- Flat ribbon cable X3cg to the hotlink adapter

- Flat ribbon cable X1a – X7a on the trailing cable interface

Fig.24: Ground cable connection

► Screw all ground cables to the earthing panel (1).

- Trailing cable cover (2) -> earthing panel

- Trailing cable interface board (3) -> earthing

panel

- Trailing cable interface support (4) -> earthing

panel

- Side part (5) -> earthing panel

- Ground cable for GCU carrier -> earthing panel

► Attach the side cover to the trailing cable with two screws.

► After completing all work, check that all cables have been run correctly and fit them into place

with cable ties, where needed.

If the machine is not fitted with a second gantry, you have to secure the trailing cable.

Fig.25: Trailing cable bracket

1. Fixture for trailing cable bracket

► Use the star screw(1) to fix the trailing cable

bracket to the GCU carrier.

 WARNING!

Gantry crash!

The trailing cable bracket must be removed if

you fit a second gantry!

3 Fitting the Prepare Kit

3.5 Fitting the Trailing Cable

Assembly Instructions / Montageanleitung SIPLACE SX1/SX2

Prepare Kit 04/2017

Fig.26: Fixture for trailing cable

► Clamp the trailing cable into the bracket, as

shown in the diagram.

► Connect the compressed air line for the second gantry that is located in the infrastructure box

1 to the compressed air supply.