DR4900 用户手册_Full version.pdf - 第5页

Specification Details Certifications CE, UKCA, CMIM, FCC, ISED, certified to UL and CSA safety standards by TÜV Warranty 1 year (EU: 2 years) Section 3 General information In no event will the manufacturer be liable for …

100%1 / 164
Section 2 Specifications
Specifications are subject to change without notice.
Specification Details
Dimensions (W x H x D) 255 x 226 x 344 mm (10.03 x 8.9 x 13.5 inch)
Enclosure rating IP20 (not included: interfaces and power supply)
Weight 4.8 kg (10.58 lb)
Pollution degree 2
Overvoltage category II
Protection class Class I
Measurement mode Transmittance (%), absorbance (Abs) or concentration
Light source Halogen lamp
Wavelength range 320 to 1100 nm
Wavelength accuracy ±1.5 nm (340 to 900 nm)
Wavelength reproducibility ±0.1 nm
Wavelength resolution 1 nm
Wavelength calibration Automatic
Wavelength selection Automatic, based on the selected procedure or measurement mode
Scanning speed 19 nm/s (in increments of 1 nm)
Spectral bandwidth 5 nm
Photometric measuring range ±3.0 Abs (340 to 900 nm)
Photometric accuracy 5 mAbs at 0.0 to 0.5 Abs
1% at 0.50 to 2.0 Abs
Photometric linearity < 0.5% to 2 Abs
≤ 1% at > 2 Abs with neutral glass at 546 nm
Stray light < 0.1% T at 340 nm with NaNO
2
Data log 10000 measured values (measured values, date, time, sample ID, user ID)
User programs > 100 user programs
Power requirements Power adapter
Input: 100–240 VAC (264 VAC maximum; 90 VAC minimum)/50–60 Hz
Output: 15 V/40 VA
Communications Use only shielded cable with maximum length of 3 m (9.8 ft) for:
USB type A and type C (front side)
USB type A and type C (back side)
Use only shielded cable (e.g., STP, FTP, S/FTP) with maximum length of 20 m
(65.6 ft) for:
1x Ethernet
Environmental conditions Indoor use only
Operating temperature 10 to 40 °C (50 to 104 °F), maximum 80% relative humidity, non-condensing
Storage temperature –40 to 60 °C (–40 to 140 °F), maximum 80% relative humidity, non-condensing
Altitude 2000 m (6562 ft) maximum
4 English
Specification Details
Certifications CE, UKCA, CMIM, FCC, ISED, certified to UL and CSA safety standards by TÜV
Warranty 1 year (EU: 2 years)
Section 3 General information
In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages resulting from any defect or omission in this manual unless otherwise required by
applicable law or contract between the parties. The manufacturer reserves the right to make changes
in this manual and the products it describes at any time, without notice or obligation. Revised editions
are found on the manufacturer’s website.
3.1 Safety information
The manufacturer is not responsible for any damages due to misapplication or misuse of this product
including, without limitation, direct, incidental and consequential damages, and disclaims such
damages to the full extent permitted under applicable law. The user is solely responsible to identify
critical application risks and install appropriate mechanisms to protect processes during a possible
equipment malfunction.
Please read this entire manual before unpacking, setting up or operating this equipment. Pay
attention to all danger and caution statements. Failure to do so could result in serious injury to the
operator or damage to the equipment.
If the equipment is used in a manner that is not specified by the manufacturer, the protection
provided by the equipment may be impaired. Do not use or install this equipment in any manner
other than that specified in this manual.
3.1.1 Use of hazard information
D A N G E R
Indicates a potentially or imminently hazardous situation which, if not avoided, will result in death or serious injury.
W A R N I N G
Indicates a potentially or imminently hazardous situation which, if not avoided, could result in death or serious
injury.
C A U T I O N
Indicates a potentially hazardous situation that may result in minor or moderate injury.
N O T I C E
Indicates a situation which, if not avoided, may cause damage to the instrument. Information that requires special
emphasis.
3.1.2 Precautionary labels
Read all labels and tags attached to the instrument. Personal injury or damage to the instrument
could occur if not observed. A symbol on the instrument is referenced in the manual with a
precautionary statement.
This is the safety alert symbol. Obey all safety messages that follow this symbol to avoid potential
injury. If on the instrument, refer to the instruction manual for operation or safety information.
Electrical equipment marked with this symbol may not be disposed of in European domestic or public
disposal systems. Return old or end-of-life equipment to the manufacturer for disposal at no charge to
the user.
English 5
3.1.3 Chemical and biological safety
D A N G E R
Chemical or biological hazards. If this instrument is used to monitor a treatment process and/or
chemical feed system for which there are regulatory limits and monitoring requirements related to
public health, public safety, food or beverage manufacture or processing, it is the responsibility of the
user of this instrument to know and abide by any applicable regulation and to have sufficient and
appropriate mechanisms in place for compliance with applicable regulations in the event of
malfunction of the instrument.
D A N G E R
Fire hazard. This product is not designed for use with flammable liquids.
• Do not use the instrument in samples that could cause a biological hazard.
• Observe all cautionary information printed on the original solution containers and safety data
sheets prior to their use.
• Dispose of all consumed solutions in accordance with the local and national regulations and laws.
• Select the type of protective equipment suitable to the concentration and quantity of the dangerous
material being used.
3.1.4 Korean certification
Company name: Hach Lange GmbH
Name of the product: Measurement and Test equipment
Model name: DR4900
Time of manufacture : > 2026-05
Manufacturer : Hach Lange GmbH / Germany
Management number : hle-DR4900
https://www.rra.go.kr/selform/hle-DR4900
3.2 Product overview
N O T I C E
Perchlorate Material—Special handling may apply. Refer to www.dtsc.ca.gov/perchlorate. This perchlorate
warning applies only to primary batteries (provided singly or installed on this equipment) when sold or distributed
in California, USA.
The DR4900 is a VIS spectrophotometer that measures in the wavelength range of 320 to 1100 nm.
The instrument is used to measure various parameters in drinking water, wastewater and industrial
applications. The instrument comes with a complete set of application programs: Hach programs
(pre-installed methods), LCK or TNTplus methods (barcode programs), user programs, single
wavelength, multi-wavelength, wavelength scan and time course modes. Refer to Figure 1.
6
English