X-Series-Maintenance-Manual(1).pdf - 第84页

Major Maintenance Maintenance Tasks for C&P2 0A Head Performing Maintenance Tasks 84 Maintenance Manual SIPLACE X Series Performing Maintenan ce Tasks 5.5.5 Performing Maintenance Tasks Oiling the DP Driver Bearing 5…

100%1 / 118
Major Maintenance
Overview of Lubrication Points Maintenance Tasks for C&P20A Head
Maintenance Manual SIPLACE X Series 83
Overview of Lubrication Points
5.5.4 Overview of Lubrication Points
Z linear guide
2 x 4 µl Lubcon Thermoplex ALN 1001/00 (blue combitip)
per ball groove
DP segment guide
2 x 2 µl Lubcon Thermoplex ALN 1001/00 (blue combitip)
per ball groove at each segment
Driver bearing
C&P20:
1 x 1 µl Nye Synthetic Oil 200A (white combitip) per driver
bearing
C&P20A:
1 x 1 µl Klüberalfa DH 3-100 (black combitip) per driver
bearing
Major Maintenance
Maintenance Tasks for C&P20A Head Performing Maintenance Tasks
84 Maintenance Manual SIPLACE X Series
Performing Maintenance Tasks
5.5.5 Performing Maintenance Tasks
Oiling the DP Driver Bearing
5.5.5.1 Oiling the DP Driver Bearing
► C&P20: For this maintenance task, use the white combitip with Nye Synthetic Oil 200A.
► C&P20A: For this maintenance task, use the black combitip with Klüberalfa DH 3-100.
► Set the multipette to 1 µl.
► Rotate the star three times and wipe away any lubricant which appears with the blotting paper.
► Fit the removed nozzle back into place.
► Remove the blotting paper.
► Rotate the star so that segment 1 can be seen in the
center of the service hole.
► Carefully push a strip of blotting paper (1) under the
service hole (2) between the head housing and the
raceway. The blotting paper should soak up any
excess oil.
► Mark the first segment by removing a nozzle.
► Position the multipette on the top edge of the locking
pin and apply 1 µl of lubricant.
Repeat this step for all segments.
Major Maintenance
Performing Maintenance Tasks Maintenance Tasks for C&P20A Head
Maintenance Manual SIPLACE X Series 85
Oiling the DP Segment Guide
5.5.5.2 Oiling the DP Segment Guide
► For this maintenance task, use the blue combitip with
Thermoplex ALN 1001/00.
► Set the multipette to 2 µl.
► Clamp the rubber hose (1) between the Z axis and
the driver of the return unit.
► Mark the first segment by removing a nozzle.
► Move the segment on the Z axis rotor out as far as the
end stop. Make sure that the driver bearing is in the
center of the jaws.
► Apply 2 µl of lubricant to the center of each guide
track (left and right side).