X-Series-Maintenance-Manual(1).pdf - 第86页
Major Maintenance Maintenance Tasks for C&P2 0A Head Performing Maintenance Tasks 86 Maintenance Manual SIPLACE X Series ► Move the segment on the Z axis r o tor out as f ar as the end stop . Make sur e that the driv…
Major Maintenance
Performing Maintenance Tasks Maintenance Tasks for C&P20A Head
Maintenance Manual SIPLACE X Series 85
Oiling the DP Segment Guide
5.5.5.2 Oiling the DP Segment Guide
► For this maintenance task, use the blue combitip with
Thermoplex ALN 1001/00.
► Set the multipette to 2 µl.
► Clamp the rubber hose (1) between the Z axis and
the driver of the return unit.
► Mark the first segment by removing a nozzle.
► Move the segment on the Z axis rotor out as far as the
end stop. Make sure that the driver bearing is in the
center of the jaws.
► Apply 2 µl of lubricant to the center of each guide
track (left and right side).
Major Maintenance
Maintenance Tasks for C&P20A Head Performing Maintenance Tasks
86 Maintenance Manual SIPLACE X Series
► Move the segment on the Z axis rotor out as far as the end stop. Make sure that the driver bearing
is in the center of the jaws.
► Apply another 2 µl of lubricant to each guideway and move the segment again approx. 5 times.
A total of 4 µl must be applied to each guideway.
► Move the Z axis upwards again.
► Make sure that the driver bearing is in the center of the jaws.
► Turn the star on to the next segment.
► Repeat this maintenance task for all segments.
► Fit the removed nozzle back into place.
Oiling th e Z Axis Lin ear Guidance
5.5.5.3 Oiling the Z Axis Linear Guidance
► For this maintenance task, use the blue combitip with Thermoplex ALN 1001/00.
► Set the multipette to 4 µl.
► Move the segment on the Z axis rotor manually out as
far as the end stop and back in approx. 5 times.
► Hold the Z axis by the rotor, in its uppermost position.
► Apply 4 µl of lubricant to the outer guideway of the
rail.
Make sure that the application nozzle is positioned
near to the guidance trolley.
Major Maintenance
Performing Maintenance Tasks Maintenance Tasks for C&P20A Head
Maintenance Manual SIPLACE X Series 87
► Remove the black rubber hose between the Z axis and the driver.
Checkin g/Replaci ng the Filter Disk s
5.5.5.4 Checking/Replacing the Filter Disks
Check
► Move the Z axis into its bottom position.
► Apply 4 µl of lubricant to the inner and outer guideway
of the rail and move the Z axis approx. 5 times
manually in and out.
► Apply another 4 µl of lubricant to the inner and outer
guideway of the rail and move the Z axis again
approx. 5 times manually in and out.
CAUTION
Remove rubber hose
If the rubber hose is not removed, the head will crash!
NOTICE
Check correct function
Check that the filter disks and vacuum distributors are working correctly by checking the
vacuum values in the software.
► Check the filter disks for contamination or damage.
► Replace any damaged filter disks.