TRS Advanced WB Intel Issue 02.pdf - 第3页
Issue 2, Nov 14 TRS Advanced Maintenance 3 TRS Advanced (L3) INDIVIDUAL PERFORMANCE OBJECTIVES Name: Departmen t : Job Title: WWID: Objectives Meth Code Date Tra inee Instruc tor Introduction HO 1 Locate the hazardous ar…
TRS Advanced Maintenance
2
Issue 2, Nov 14
Issue 2, Nov 14
TRS Advanced Maintenance
3
TRS Advanced (L3) INDIVIDUAL PERFORMANCE OBJECTIVES
Name: Department:
Job Title:
WWID:
Objectives
Meth
Code
Date Trainee Instructor
Introduction
HO 1
Locate the hazardous areas of the machine / option. DKO
2
Identify the key benefits and features of the TRS
option.
DKO
Overview
3 Identify the components of the TRS option DKO
4 Theory of operation DKO
Electrical
5 CAN System Refresh DKO
6 Identify Node 19 Board and explain its function DKW
7 Locate, identify and test all TRS sensors and switches.
DPI/
DKW
Mechanical
8 Rail Alignment Jig DKO
9 Remove / Replace TRA Actuatros DPI
10 Remove and Replace Stripper Pins DPI
11 Remove and Replace Interlock pins DPI
12 Remove and Re-fit Active Surround DPI
13 Remove and Refit Rail Cap DPI
14 Remove and re-fit rail cap bearings DPI
15 Setup Rail at Tooling Vane (RAT) DPI
16
Remove and re-fit auxiliary and center sections
transport rails. Set the rails (using rail alignment jig)
DPI
17 Auxiliary and center section transport rails setting DPI
18 Maintain Tooling Tower System (replace parts) DPI
19 Explain how Z-Lock mechanism works DKW
20 Replace pull down reference cylinders DPI
TRS Advanced Maintenance
4
Issue 2, Nov 14
Pneumatic
21 Identify and locate all pneumatic components of TRS DKO
22
Understand the operation and limitations of a Venturi
Vacuum System
DKO/
DKW
23 Test Performance of Venturi Vaccum DPI
24 Test Vacuum performance through Tooling Towers DPI
Software
25 Use of Diagnostics to test operation DPI
26 Enable / Disable the TRS system/Soft Lift&Land Para. DPI
27 Locate and understand “timing.ini” file DKW
Calibration and Co-Planarity
28 Co-Plane the Machine DPI
29
Check / Calibrate TRP Home and TRP Over Rails
Sensors
DPI
30 Check / Set Rising Table Home Position DPI
31 Calibrate Camera Reference Position DPI
32 Calibrate Vision Height DPI
33 Calibrate Print Height DPI
34 Calibrate Rail Width DPI
35 Calibrate Squeegee Pressure DPI
36 Calibrate Vision and Offset DPI
37 TRS dual belt speed motor setting (belt speed setting) DPI
38 Run SPC and troubleshoot if necessary DPI
Pre-Production Setup
39 TRA Pitch adjustment, Plate Offset Jig (POJ) DPI
40 Check TRA Gap and adjust (Level Adjustment) DPI
41 Set-up board stop DPI
42 Baseline Data Information DKO
43 Process Fault Finding DKO
44 Locate and identify drip trays in the printer DKO
45 Remove and refit left side safety cover DPI
46 Transportation of the TRS Unit DPI
47 Converting machine to Strip Handling Option DPI