TRS Advanced WB Intel Issue 02.pdf - 第42页

TRS Advanced Maintenance 42 Issue 2, Nov 14 Carry out the following; 1. Fit 2x board clamp height setti ng blocks (212649) on to the cent er section front rail at the locations shown the picture below. 2. Rotate the bloc…

Issue 2, Nov 14

TRS Advanced Maintenance

Objective 16: Remove and re-fit the Centre and Auxiliary Rail sections

1. Remove tooling assembly from the TRS unit if fitted.

2. Remove rail cap assembly from the transport rails (by following the rail cap removing

procedure), if fitted.

3. Remove left and right auxiliary transport rails assemblies and center section transport

rail assembly from the machine.

Left Side Auxiliary Transport

Rail Assembly

Right Side Auxiliary Transport

Rail Assembly

Centre Section Transport

Rail Assembly

TRS Advanced Maintenance

Issue 2, Nov 14

Carry out the following;

1. Fit 2x board clamp height setting blocks (212649) on to the center section front rail at the

locations shown the picture below.

2. Rotate the blocks inward, gaps facing in and tighten the attached captive screws.

Record the measured gap values here:

Rear Left

Rear Right

Front Left Front Right

Only two board clamp height setting blocks are supplied. Set the front rail first then

change over to set rear rail.

Close View on Board Clamp Height Setting Block

Rail Top Face

BOARD CLAMP HEIGHT

SETTING BLOCKS (212649)

Issue 2, Nov 14

TRS Advanced Maintenance

3. Subtract 1.2mm from the measured gap values above to determine the feeler gauge

thickness required in each location to achieve the correct gap and height setting.

NOTE

Using an Allen key on M4x8 cap head screw (on the rail clamp adjustment block

assembly), adjust the height of the Board Clamp Plates evenly using the calculated feeler

gauge thicknesses.

4. The top face of the Board Clamp Plate must be set @ 1.2mm +0.05/-0.00 higher than the

top face of the Centre Rail extrusion.

5. Use the measured gaps above to calculate the correct amount of feeler gauge required

and set the Board Clamp Height to within 0.05mm

Adjustment Block

Lock Nut

Adjustment Screw

View on Rear of Front Central Rail Section

Feeler Gauge

Set the board clamp plate height using the

“Rail Cap Adjustment Block Assembly”