TRS Advanced WB Intel Issue 02.pdf - 第45页

Issue 2, Nov 14 TRS Advanced Maintenance 45 9. Tighten the Lock Nuts on both and of the ce nter section rail clamp adjustment block assembly. 10. Re-check gaps & Varni-Stop if OK. 11. Repeat the height setting proced…

TRS Advanced Maintenance

Issue 2, Nov 14

6. Rotate both of the Setting Blocks forwards and out over the Board Clamp plate.

7. Using an Allen key on M4x8 cap head screw (on the rail clamp adjustment block

assembly), adjust the height of the Board Clamp Plates evenly using the calculated feeler

gauge thicknesses.

8. Continue fine adjustment until adding a

0.05 gauge makes the gap under each

Setting Block a very tight GO / borderline

NOGO.

View on Rail Clamp Adjustment Block Assembly

M4x8 Cap Head Screw

Board Clam

Plate

Issue 2, Nov 14

TRS Advanced Maintenance

9. Tighten the Lock Nuts on both and of the center section rail clamp adjustment block

assembly.

10. Re-check gaps & Varni-Stop if OK.

11. Repeat the height setting procedure for the rear center rail section.

12. Replace the 4x locating plates by using 8 off M3x8 pan head screws.

13. Apply pink Loctite 222 to each screws re-fit and after fully tighten them, back off each

screw by ½ turn.

14. Unscrew & remove the Board Clamp Height Setting Blocks. (212649 x2).

View on Rail Clamp Adjustment Block Assembly

M4x8 Cap Head Screw

M8x0.75 Nut Lock

158932

Board clamp height setting

blocks (212649x2)

TRS Advanced Maintenance

Issue 2, Nov 14

15. Re-align the plastic belt guides (2 front, 2 rear) with the belt support as shown below.