TRS Advanced WB Intel Issue 02.pdf - 第89页
Issue 2, Nov 14 TRS Advanced Maintenance 89 Objective 21: Identify and locate al l Pneumatic components on the machine. Mains in regulator Solenoid bank Z-lock Cylinder Hi-Flow Venturi Vacuum Unit MEK Air Pressure Regula…
TRS Advanced Maintenance
88
Issue 2, Nov 14
15. After printing the rising table lowers at separation height and separation speed to vision
height. Post inspection commences, if required.
16. The active surround pusher plate retracts. The substrates settle in the handler.
17. The vacuum turns OFF.
18. The table returns to transport height.
19. The snugger plate retracts.
20. The handler is released and unloads.
Issue 2, Nov 14
TRS Advanced Maintenance
89
Objective 21: Identify and locate all Pneumatic components on the machine.
Mains in regulator
Solenoid bank
Z-lock Cylinder
Hi-Flow Venturi Vacuum Unit
MEK Air Pressure Regulator
TRA Cylinders
Pull Down Reference Cylinders
Board Stop Pneumatics
Rear Rail Snugger
Active Surround Actuator
Vacuum Leak Sensor
Set the Mains In regulator to correct pressure:
Set the Low Pressure switch to the correct value and test
Questions
1. What value should the Mains In regulator be set to? _____________________
2. What value should the Low Pressure Switch be set to? __________________
3. What should you do if regular ‘Pneumatic Power Down’ messages are seen on the
machine?
NOTES:
TRS
A
90
Obj
e
How
A
dvanced
M
e
ctive 22:
U
S
a Venturi
V
M
aintenanc
e
U
ndersta
n
System
V
acuum
S
e
n
d the op
e
S
ystem wo
r
e
ration an
r
ks:
n
d limitati
o
o
n of a Hi
-
Issu
-
Flow Ven
u
e 2, Nov 14
turi Vacu
u
u
m