TRS Advanced WB Intel Issue 02.pdf - 第79页

Issue 2, Nov 14 TRS Advanced Maintenance 79 Replacement Procedure NOTE Remove pull down referenc e cylinder one at a time. 1. Label three pneumatic pipes attach to right side pull down reference cylinder and note the rou…

100%1 / 141
TRS
A
78
Obj
e
The
p
rear
o
the f
o
over
A
dvanced
M
e
ctive 20:
R
p
ull down
r
o
f rail cap.
o
rks on th
e
the Active
M
aintenanc
e
R
emove
a
r
eference
c
Their pur
p
e
arms to
e
Surround
.
e
a
nd Repla
c
c
ylinders
a
p
ose is to
e
e
ngage, th
e
.
c
e the Pu
l
a
re two pn
e
e
xtend wh
e
cylinder
s
l
l Down R
e
e
umatic c
y
en the pla
t
s
are then
e
ference
C
y
linders sit
u
t
e is move
retracted
w
Issu
C
ylinders
u
ated on t
h
d over the
w
hich pull
s
u
e 2, Nov 14
h
e MEK a
t
rails, this
s
the plate
t
the
allows
down
Issue 2, Nov 14
TRS Advanced Maintenance
79
Replacement Procedure
NOTE
Remove pull down reference cylinder one at a time.
1. Label three pneumatic pipes attach to right side pull down reference cylinder and note
the routing.
2. Disconnect three pneumatic pipes from the right side of pull down reference cylinder
assembly.
3. Undo 4 of M5x75 cap head screws and remove with M5 spring washers, M5 washers.
4. Carefully remove reference cylinder assembly from the TRS unit.
5. Repeat Steps 1 to 4 for left side pull down reference cylinder.
M5x75 Cap Head Screws
(8 Positions)
M5 Washer
(Reduced od)
(8 Positions)
M5 Spring Washer
(8 Positions)
Right and Left Side Pull Down Reference Cylinders
TRS Advanced Maintenance
80
Issue 2, Nov 14
6. Carefully, remove double elbow pneumatic fitting and male elbow pneumatic fitting from
the right side pull down reference cylinder.
NOTE
1. Keep pneumatic fittings safe for future use.
2. If using a new flow controller set them fully in and back off 5 and a 1/4 turns by using
a special tool as shown below. Apply a small dot of Varnistop to the outside of the
adjuster to confirm setting has been done.
Locating Cap
M8x25 Slotted Countersunk Screw
Speed Controller
Double Elbow pneumatic
Fitting
Male Elbow Pneumatic
Fitting
Right Side Pull Down Reference
Cylinder Assembly
Left Side Pull Down Reference
Cylinder Assembly