TRS Advanced WB Intel Issue 02.pdf - 第63页
Issue 2, Nov 14 TRS Advanced Maintenance 63 75. Slacken off the M5 rail pad mounting screws (6 off, with spring was her s) on the front and rear rails allowing the rail pads to drop into contact with the MEK reference su…
TRS Advanced Maintenance
62
Issue 2, Nov 14
73. Re-locate the 2x rear Height Setting Pins behind the rail as it comes forward.
74. Using a 0.05mm feeler gauge, check that all four of the height setting pins are fully in
contact with the rail rap and MEK Base.
NOTE
The feeler gauge should be NOGO.
Issue 2, Nov 14
TRS Advanced Maintenance
63
75. Slacken off the M5 rail pad mounting screws (6 off, with spring washers) on the front and
rear rails allowing the rail pads to drop into contact with the MEK reference surfaces. Rail
support pads have a single point contact.
76. Remove each of the 6 screws in turn, apply blue Loctite 243 and replace (on the front
and the rear rails).
77. Keep the rail pads in contact with the MEK reference surfaces and fully tighten all 6 off
screws (3 off on front and 3 off on rear rails).
78. With a 0.05mm feeler gauge, check that the height setting pins are still fully in contact
with the rail cap and MEK base.
TRS Advanced Maintenance
64
Issue 2, Nov 14
79. The two alignment bearing guide rods at the rear of the rail cap need to be adjusted
one side at a time. Undo the 3 off M5 cap head screws on the rear corner of the rail
cap so that alignment bearing guide rods can move freely.