TRS Advanced WB Intel Issue 02.pdf - 第41页

Issue 2, Nov 14 TRS Advanced Maintenance 41 Objective 16: Remove and re-fit the Ce ntre and Auxiliary Rail sections 1. Remove tooling assembly from the TRS unit if fitted. 2. Remove rail cap assembly from the tr ansport …

TRS Advanced Maintenance

Issue 2, Nov 14

Objective 15: Rail at Tooling (RAT) Vane Setup

Set the RAT vane from the rear of the rail cap assembly, carry out the following:

- In Diagnostics, drive the rising table to VISION Height.

- Go to the System, highlight and select Display All Digital Inputs.

- Select Node 19 Group 0 to set up RAT sensor operation.

- Adjust the RAT sensor vane by adjusting M3x20 button head screw clockwise or anti-

clockwise so that it just triggers the sensor state to OFF in Diagnostics display.

NOTE

When adjusting sensor keep pressure on the screw.

- Rotate the screw anti-clockwise until sensor states just changes to ON.

- Rotate the screw anti-clockwise extra one 1/4 turn.

Viewed from Rear of the TRS Unit

Rail Cap Assembly

M3x20 Button

Head Screw

Issue 2, Nov 14

TRS Advanced Maintenance

Objective 16: Remove and re-fit the Centre and Auxiliary Rail sections

1. Remove tooling assembly from the TRS unit if fitted.

2. Remove rail cap assembly from the transport rails (by following the rail cap removing

procedure), if fitted.

3. Remove left and right auxiliary transport rails assemblies and center section transport

rail assembly from the machine.

Left Side Auxiliary Transport

Rail Assembly

Right Side Auxiliary Transport

Rail Assembly

Centre Section Transport

Rail Assembly

TRS Advanced Maintenance

Issue 2, Nov 14

Carry out the following;

1. Fit 2x board clamp height setting blocks (212649) on to the center section front rail at the

locations shown the picture below.

2. Rotate the blocks inward, gaps facing in and tighten the attached captive screws.

Record the measured gap values here:

Rear Left

Rear Right

Front Left Front Right

Only two board clamp height setting blocks are supplied. Set the front rail first then

change over to set rear rail.

Close View on Board Clamp Height Setting Block

Rail Top Face

BOARD CLAMP HEIGHT

SETTING BLOCKS (212649)