00198628-01_Option_Stationäre-Kamera_TX12_V2_de_en.pdf - 第93页
3 Installation 3.4 Fitting the Stationary Camera Type SST33 Assembly Instructions / Montageanleitung SIPLACE TX-Series V2 Stationary Camera Type 25/33 Stationäre Kamera Typ 25/33 10/2018 93 Fig.47: Fixing the camera ► S…
3 Installation
3.4 Fitting the Stationary Camera Type SST33
92 Assembly Instructions / Montageanleitung SIPLACE TX-Series V2 Stationary Camera Type 25/33 Stationäre Kamera
Typ 25/33 10/2018
Fig.44: Camera spacer plate
► Screw on the camera distance plate [03136559-
xx] using the six screws [03042574-xx].
Fig.45: Hooking in the basic camera unit
► Place the basic camera unit at its installation
position from above.
► Hook the basic camera unit on the two screws (1)
using the upper keyholes.
Fig.46: Checking the installation height
► Check the installation height of the camera. The
camera must be fitted to the lowest positionI(1).
3 Installation
3.4 Fitting the Stationary Camera Type SST33
Assembly Instructions / Montageanleitung SIPLACE TX-Series V2 Stationary Camera Type 25/33 Stationäre Kamera
Typ 25/33 10/2018
93
Fig.47: Fixing the camera
► Screw two more screws(2) ISO4762-M6x25-
A2-70 [03042575‑xx] into the lower keyholes.
► Screw all four screws(1) and(2) tight.
Establishing electrical connections
Fig.48: Connection for GigE cable
1. Connection for GigE cable (1)
Fig.49: Connection for power cable cable
1. Connection for power cable cable (2)
3 Installation
3.4 Fitting the Stationary Camera Type SST33
94 Assembly Instructions / Montageanleitung SIPLACE TX-Series V2 Stationary Camera Type 25/33 Stationäre Kamera
Typ 25/33 10/2018
Fig.50: Connection for CAN bus cable
Connection for CAN bus cable (3)
Multiplexer (not in use) (4).
Fig.51: Connections on the machine
1. GigE cable W3: Extension camera bus stat.
camera [03148099-xx]
2. Power cable: Extension power stat. camera
W1[03148097-xx]
3. CAN bus cable W2: Extension CAN bus stat.
camera [03148098-xx]
Fig.52: Establishing electrical connections
► Run the cables (1), (2) and (3) from the camera
to the pneumatics feedthrough.
► Connect the cables.
NOTICE!
Make sure to connect the GigE cable correctly.
The multiplexer connection at the lower end of
the board is not used.
.