00198631-03_AI_Smart-Pin-Support_TX_DE_EN.pdf - 第64页

3 Installation 3.3 Gantry 1 64 Assembly Instructions / Montageanleitung SIPLACE TX V2 Series Smart Pin Support 07/2021 3.3.3 Preparing the gantry Fig.17: Board cover ► Remove the five fastening screws and lift the board…

100%1 / 82
3 Installation
3.3 Gantry 1
Assembly Instructions / Montageanleitung SIPLACE TX V2 Series Smart Pin Support 07/2021 63
3.3 Gantry 1
3.3.1 Converting the Y axis buffer
Fig.14: Removing the old buffers
► Remove the two buffers(1).
Fig.15: Fitting the new buffers
► Screw the new buffers on(1) (Loc-
tite243).
► Fit the support plate(2) with two
screws (M4x6, Allen2.5, Loctite243).
3.3.2 Converting the X axis buffer
Fig.16: Bottom rubber buffer
► Dismantle the bottom rubber buffer(1)
at the gantry root (Allen, M6).
► At the gantry root, attach the spacer(2)
[03210576‑xx] with a screw (M6x35).
Use the shortened Allen key for this.
► Refit the previously removed rubber
buffer on the spacer (Allen5, M6).
3 Installation
3.3 Gantry 1
64 Assembly Instructions / Montageanleitung SIPLACE TX V2 Series Smart Pin Support 07/2021
3.3.3 Preparing the gantry
Fig.17: Board cover
► Remove the five fastening screws and
lift the board cover(1) off.
Fig.18: Disconnecting the exhaust air hose
► Loosen the cable ties(1).
► Disconnect the exhaust air hose from
the silencer(2) (top) and from the air
connection(3) for cooling the X motor
plate (bottom),
Fig.19: Removing the silencer
► Disconnect the hose(1) from the silen-
cer(3).
► Remove the two screws(2) (Allen2.5,
M3x25) and lift off the silencer.
Make sure not to lose the two disks.
3 Installation
3.3 Gantry 1
Assembly Instructions / Montageanleitung SIPLACE TX V2 Series Smart Pin Support 07/2021 65
Fig.20: Removing the cooling
► Remove the two screws (Allen2.5) and
lift off the air connection(1) for cooling
the X motor plate.
► Fit the new air connection(2)
[03210185-xx] with two screws (M3x14,
Allen2.5, torque 1.3Nm, Loctite241).
Fig.21: Removing the plate
► Remove the two screws(1) (M3x6, but-
ton head, Torx10).
► Remove the two screws(2) (M3x12,
Allen2.5).
► Remove the three screws(3) (M6x14,
Allen5) and lift off the side plate of the
X holder(4).