00198631-03_AI_Smart-Pin-Support_TX_DE_EN.pdf - 第74页

3 Installation 3.4 Gantry 2 74 Assembly Instructions / Montageanleitung SIPLACE TX V2 Series Smart Pin Support 07/2021 Fig.44: Removing the blanking plug ► Remove the blanking plug (1) at the pneumatic distributor. ► C…

3 Installation

3.4 Gantry 2

Assembly Instructions / Montageanleitung SIPLACE TX V2 Series Smart Pin Support 07/2021 73

3.4.3 Installing the pin picker

Fig.41: Inserting the pin picker

► Place the pin picker (including the side

plate) on the gantry.

 NOTICE!

Centering pins

The pin picker has two centering pins.

First, position the bottom centering pin

and after that the top one.

The base plate of the pin picker must

fit closely.

Fig.42: Fastening the pin picker

 CAUTION!

Observe the specified order

To minimize tension, first tighten the

screws(1) to(3) and after that the top

screws(4).

► Fasten the pin picker with eight screws:

1. 1x M4x14, Allen3

Torque 2.9Nm, Loctite243

2. 3x M6x14, Allen5

Torque 10Nm, Loctite243

3. 2x M3x12, Allen2.5

Torque 1.3Nm, Loctite243

4. 2x M3x6, Torx10, button head

[03119157‑xx]

Loctite243

Fig.43: Shortening the hose

► Lift off the T piece and shorten the

hose(1) (4x2.5PUN) of the pin picker

by 70mm to a length of 280mm.

3 Installation

3.4 Gantry 2

74 Assembly Instructions / Montageanleitung SIPLACE TX V2 Series Smart Pin Support 07/2021

Fig.44: Removing the blanking plug

► Remove the blanking plug(1) at the

pneumatic distributor.

► Connect the hose of the pin picker to

the pneumatic distributor.

Fig.45: Running the cables

► Connect the "connection cable SPS TX

V2" [03208588‑xx] to the head inter-

face (X13).

► Make sure that the cable is run cor-

rectly.

► Secure the cables and hoses with

cable ties.

3 Installation

3.5 Smart Pin Magazine T5 (PinFeeder)

Assembly Instructions / Montageanleitung SIPLACE TX V2 Series Smart Pin Support 07/2021 75

3.5 Smart Pin Magazine T5 (PinFeeder)

Fig.46: Pin feeder

At least one pin feeder must be inserted in

track 1 at each component table. You can

set up more than one pin feeder per compo-

nent table (up to and including track25).

The pin feeders on track1 must not be

removed from the component tables as they

provide the table fiducial. For the production,

additional pin feeders can be removed and

replaced by other feeders after the support

pins have been picked up.

Placing the pin feeder

Fig.47: Setting up the pin feeder

► Hold the pin feeder with both hands

and push it on track1 into the compo-

nent table.

ð The pin feeder is automatically re-

cognized and calibrated by the sta-

tion software. The button on the pin

feeder lights green.

ð If support pins are needed, these

will be automatically picked up and

placed.

Removing the pin feeder

Fig.48: Pin feeder button

► Press the button (1) on the pin feeder.

ð The pin feeder is logged off. The

button does not light any longer.

► Pull the pin feeder out of the compo-

nent table.