CP6的IO代码.pdf - 第271页

8. Manually feed the part and check the pick-up position. To feed the part one pitch, push the feed lever down in the direction of the arrow as shown. In so doing, the part is fed one pitch at a time. Confirm that the pi…

7. After feeding the top-film through the rollers, turn the take-up reel in the direction

of the arrow as shown. When the top-film is wound too tight, it is necessary to

turn the take-up reel in the opposite direction. Because there is resistance in the

take-up reel axis, it is necessary to use a little force when turning.

Setting the Top-film

Note: Take-up problems may occur if the top-film is not set properly.

W8, W12 x P4

W12 x P8

Roller

Top-film

CP6M8012

Part 8 Chapter 1 WC Feeders

Edition 1.0 8-1-8 CP-6 Series Mechanical Reference

8. Manually feed the part and check the pick-up position. To feed the part one pitch,

push the feed lever down in the direction of the arrow as shown. In so doing, the

part is fed one pitch at a time. Confirm that the pick-up position is as shown in the

bottom illustration. Cut the tape that extends past the end of the feeder with

scissors.

Confirming Pickup Position

Note: Feed problems may arise when using your hand to tear off tape.

Confirming Pick-up Position

Pick-up point

CP6M8014

Tape feed lever

CP6M8013

Part 8 Chapter 1 WC Feeders

Edition 1.0 8-1-9 CP-6 Series Mechanical Reference

1.5 Loading W12 x P12, W16, W24, W32, W44 Embossed

Feeders

1.5.1 Loading Procedures

1. The tape leaf is released by raising up the tape leaf while pushing in the catch pins

(one on right side and one on left side). After it is unlocked, raise the tape leaf in

the direction of the arrow as shown.

Unlocking the Tape Leaf

2. Set the parts reel in the holder. When loading, check that the holes (feeding holes)

in the tape are on the left side as shown.

Setting the Parts Reel (13 inch holder)

Parts tape

Feed hole

Holder

Parts reel

CP6M8016

Tape leaf

Catch pin

Shutter

CP6M8015

Part 8 Chapter 1 WC Feeders

Edition 1.0 8-1-10 CP-6 Series Mechanical Reference