CP6的IO代码.pdf - 第315页
Select the device with the cursor and press the F7 key (error). The following information will be displayed. Production Data Display 2/2 Refer to the error code display for information on the error codes shown in the das…
2.3 Checking Errors Through Production Information
(WC Type)
It is possible to check for the presence of feeder errors through daily maintenance, but
this section explains how to check for such errors by inspecting the feeder through the
production information managed by the MCS.
Data required for feeder inspection
Compile the production data, and select MAINTENANCE.
Production Data (maintenance) – – – MAINTENANCE/DEVICE
Press the F1 key (select) and move the cursor to the desired device.
Production Data Display 1/2
MAINTENANCE - DEVICE
LINE : FUJI MC : CX0900 PROGRAM : Evaluation. W08xP02.D1
DATE : 96/03/21 09:11:02 - 96/03/23 00:00:00
D_NO. D_COMMENT
PARTS
ERROR
JUNK RATE 0 50 100%
001
resistor
2125T04. 1 20090 90 0 0.45
002
resistor
2125T04. 2 20000 0 0 0.00
003
resistor
2125T04. 3
20150 150 0 0.74
TOTAL 60240 240 0 0.39
(F1) (F2) (F3) (F4) (F5) (F6) (F7) (F8)
*----------------------------------------------------------------------------------------------------*
*----------------------------------------------------------------------------------------------------*
*----------------------------------------------------------------------------------------------------*
*----------------------------------------------------------------------------------------------------*
select
copla print
head nozzle error end
CP6M8081
Part 8 Chapter 2 Feeder Maintenance
Edition 1.0 8-2-6 CP-6 Series Mechanical Reference
Select the device with the cursor and press the F7 key (error).
The following information will be displayed.
Production Data Display 2/2
Refer to the error code display for information on the error codes shown in the dashed
frame.
When MAINTENANCE/DEVICE is chosen, and the device generating the error selected,
it is possible to check the detailed error information, which can be used to determine if
an inspection is required.
Caution : These error results also include errors due to defective part shapes and defective
parts tape. For this reason, you should check both feeder and parts for devices which
suffer from low operating rates.
ERROR CODE :
The following error codes are representative of pick-up errors. For other errors, check the
ERROR CODE DISPLAY.
12040403 No part in nozzle
1CA0A007-1CA0A009 Error due to on-end part during pick-up
12040407 Error due to angle offset during part pick-up
MAINTENANCE - DEVICE
LINE : FUJI MC : CX0900 PROGRAM : EVALUATION. WO8xP02.D1
D_NO.
001
D_COMMENT
: RESISTOR2125T04.3
1CA0A009 26
TOTAL 150
(F1) (F2) (F3) (F4) (F5) (F6) (F7) (F8)
*----------------------------------------------------------------------------------------------------*
*----------------------------------------------------------------------------------------------------*
*----------------------------------------------------------------------------------------------------*
*----------------------------------------------------------------------------------------------------*
ERROR CODE
ERROR
1CA0A008 40
1CA0A007 12
12040403
44
12040407
28
print
end
CP6M8082
Part 8 Chapter 2 Feeder Maintenance
Edition 1.0 8-2-7 CP-6 Series Mechanical Reference
Notes:
Part 8 Chapter 2 Feeder Maintenance
Edition 1.0 8-2-8 CP-6 Series Mechanical Reference